7
En
Eng
lish
This section describes preparations required before operating this unit.
Depending on the system structure you want to establish, make cable connections of the system components.
1
Connect this unit to your amplifier with an XLR
balanced cable, RCA stereo cable, coaxial digital
audio cable or optical cable.
y
Select one of the audio connections shown above. If your
amplifier is equipped with XLR balanced input jacks, we
recommend a balanced connection for optimum audio
performance.
2
Connect this unit to your broadband router with an
STP (shielded twisted pair) network cable (CAT-5 or
higher straight cable).
3
Connect the power cable to AC IN and then plug
into an AC outlet.
■
About the spike feet
The feet of this unit include built-in spikes that can reduce
the effect of vibrations on the set. To use the spikes,
remove the magnet foot by pulling it. Also, you can adjust
the height of each foot by rotating it if this unit is unstable.
PREPARATIONS
Connections
BALANCED OUT
BALANCED OUT
NETWORK
SYSTEM CONNECTOR
DIGITAL OUT
OPTICAL
COAXIAL
AC IN
R
ANALOG OUT
OUTPUT
R
L
L
LAN
WAN
2
3
1
Speakers
Amplifier
XL
R bala
nce
d
ca
b
le
RCA
st
er
eo
c
a
b
le
(s
up
plie
d)
Opt
ica
l ca
bl
e
Coax
ia
l digit
a
l
au
dio ca
ble
PC
Internet
Modem
Broadband
router
This unit (NP-S2000) *U.S.A model
Power cable (supplied)
To AC outlet
NAS
(for full system only)
* Used for product inspection service
Caution
The spikes may scratch the shelf or floor. We recommend you use
a support when placing this unit on expensive furniture, etc.
Spike
Magnet foot