Yamaha NPS 4500, Owner'S Manual

E. Starting and Operating the Generator

 E.7

  Wireless Hand-held Remote-Start Keyfob was created to conveniently

allow

you to start/stop your Generator from a distance of fifty (50) meters (164').

See

Exhibit 6

•

To start the Generator, press and hold the "START" button for more than one (1)

second and then release the button

•

To stop the Generator, press and hold the "STOP" button for more than one (1)

second and then release the button

 E.8

  Using the Wireless Hand-held Remote-Start Keyfob for remote starting the

Generator 

See 

Exhibit 6

The Keyfob you received with your RV will have its signals already matched to the 

Generator during installation.  However, if you replace the Keyfob battery, are using a 

replacement Keyfob, or you lose your signal you will need to re-match the Generator 

and the Keyfob's wireless signals

•

To match signals connect the Generator with the RV battery source, turn the

Master 12 Volt Power Switch, inside the Generator Service Access Door, to the

"ON" position. See 

Exhibit 2

•

Press the Signal Match Set Button on the Remote Control Module and hold it for

more than three (3) seconds until the Signal Match Indicator Light on the Remote

Control Module stays on constant

•

Release the Signal Match Set Button and press the "STOP" button on the Keyfob

(at this moment the Signal Match Indicator Light on the Remote Control Module

will blink one time and then stay on constant)

•

Release the "STOP" button on the Keyfob and press the "START" button on the

Keyfob (at this moment the Signal Match Indicator Light on the Remote Control

Module will blink one time and then stay on constant)

•

Release the "START" button on the Keyfob, press and hold the Signal Match Set

Button on the Remote Control Module until the Signal Match Indicator Light on

the Remote Control Module is off

•

Start the Generator by pressing"START" on the Keyfob, then stop the Generator

by pressing "STOP" on the Keyfob to verify the signals have matched.  If the

match is not made, repeat the above procedure, until the Keyfob and Generator

wireless signals are successfully matched

Page 20 of 30

Rev 1.7