background image

5

En
gl

is

h

The front cover is fastened to the enclosure at six points 
and can be removed if desired. To remove the cover, hold 
on to both sides and slowly pull straight away from the 
speaker. To reattach, line up the six pegs on the inside 
surface of the cover with the six corresponding holes on the 
speaker and push gently.

Note

When the cover is removed, take care not to touch the speaker 
units with your hands or to exert excessive force with tools.

NS-777

Type ............................. 3-way bass reflex speaker system

Magnetic shielding type

Driver .....................................20 cm (8") cone woofer x 2

Wave guide horn 13 cm (5") cone mid-range

Wave guide horn 2.5 cm (1") dome tweeter

Frequency response.................................. 30 Hz – 35 kHz
Nominal impedance ............................................... 6 ohms
Nominal input power .............................................. 100 W
Maximum input power ........................................... 250 W
Sensitivity ................................................89 dB/2.83 V/m
Crossover frequency .................................... 1 kHz, 4 kHz
Dimensions (W x H x D)

......................................... 276 mm x 1100 mm x 390 mm

(10.9" x 43.3" x 15.4")

Weight...........................................24.4 kg (53 lbs. 13 oz.)
Accessories ........................................Stand (R x 2, L x 2)

Washer  x 4

Screw x 8

Pad x 4

NS-555

Type ............................. 3-way bass reflex speaker system

Magnetic shielding type

Driver ..................................16 cm (6.5") cone woofer x 2

Wave guide horn 13 cm (5") cone mid-range

Wave guide horn 2.5 cm (1") dome tweeter

Frequency response.................................. 35 Hz – 35 kHz
Nominal impedance ............................................... 6 ohms
Nominal input power .............................................. 100 W
Maximum input power ........................................... 250 W
Sensitivity ................................................88 dB/2.83 V/m
Crossover frequency .................................... 1 kHz, 4 kHz
Dimensions (W x H x D) ... 222 mm x 980 mm x 345 mm

(8.74"x 38.6" x 13.6")

Weight...................................................... 20 kg (44.1 lbs)
Accessories ........................................Stand (R x 2, L x 2)

Washer  x 4

Screw x 8

Pad x 4

• Specifications subject to change without notice due to 

product improvements.

• Care should be taken not to exceed the input power 

values noted above.

REMOVING THE FRONT COVER

NS-777

NS-555

SPECIFICATIONS

05AAGHO2CIG6WGUFC[/CTEJ2/

Summary of Contents for NS-555







Reviews: