4
SETTING UP THE SPEAKERS
Attaching the non-skid pads to the speakers
Place the speakers on a sturdy, vibration-free surface, such as a well-built stand. Attach the included non-skid
pads to the bottom of the speakers to prevent the speakers from slipping.
Wall mounting the front and/or surround speakers
When mounting the speakers on a wall, attach one of the non-skid pads provided near each of the corners on
the rear surface of the speaker to prevent the speaker cable from being caught between the wall and the
speaker.
You can also use the screw holes on the back of the speaker for
installing the speakers on commercially available speaker brackets.
2-3/8 (60 mm)
A screw with a diameter of
can be used.
(Hole depth:9/32 )
Wall / wall support
Tapping screw
(Available at the hardware store)
When using speaker brackets to mount the speakers on a wall or ceiling, it is strongly recommended that
safety wire, which may be included with the bracket, be used between the speaker and the bracket to prevent
the speaker from falling.
Fasten screws into a firm wall or wall support as shown in the figure, and hang the holes of the mounting
bracket on the protruding screws.
Make sure that the screws are securely caught by the narrow sections of the key hole opening.
WARNING
Each speaker weighs 2.05 lbs (0.93 kg). Do not mount the speakers on thin plywood or a wall with soft
surface material, since the screws may pull away from the surface and fall. This will damage the speakers
and can cause personal injury.
Do not mount tne speakers on a wall with nails, adhesives, or any other unstable hardware. Long-term
use and vibrations may cause them to fall.
To avoid accidents resulting from tripping over loose speaker cords, they should be affixed to the wall or
floor molding.
Secure installation is the purchaser s responsibility.
1/4
