NS-AP8805
5
Attaching the rubber base
1. Decide the location where you want to place the speaker.
2. Affix the double-sided adhesive tape on the bottom of the speaker.
3. Attach the supplied rubber bases to the speaker bottom.
Notes
l
Do not place the speaker on top of the TV if the area is smaller than the bottom area of the speaker. The
speaker may fall and might cause personal injury.
l
Do not place the speaker on top of the TV with an inclination.
l
Do not touch the adhesive surface after peeling off the seal as this will weaken its adhesive strength.
l
Thoroughly wipe clean the surface where the fastener is to be applied. Note that adhesive strength is
weakened if the surface is dirty, oily or wet and that this may cause the center speaker to drop.
l
Though this speaker is a magnetically shielded type, there may be some influence on a TV picture depending
on the type of TV or the placement of the speaker. In such a case, place the speaker apart from TV so that
there is no influence on TV picture.
WARNING
l
To avoid accidents resulting from tripping over loose speaker cords, they should be affixed to the wall or floor
molding.
l
Secure installation is the purchaser's responsibility.
WARNING
l
The each surround speaker weighs 3.53 lbs (1.6 kg) and front/center speaker weighs 5.29 lbs (2.4 kg). Do
not mount the speakers on thin plywood or a wall with soft surface material, since the screws may pull away
from the surface and fall. This will damage the speakers and can cause personal injury.
l
Do not mount the speakers on a wall with nails, adhesives, or any other unstable hardware. Long-term use
and vibrations may cause them to fall.
l
To avoid accidents resulting from tripping over loose speaker cords, they should be affixed to the wall or floor
molding.
l
Secure installation is the purchaser's responsibility.
l
Placing the center speaker
Place the speaker on the TV or inside the TV rack
so that it is stabilized.
l
Placing the center speaker on top of the
TV
Affix the supplied fasteners to the bottom of the
rubber bases. Peel off the seal and attach the center
speaker to the top of the TV.
TV set
Fastener
Peel off
the seal
NS-AP8805C
Double-sided
adhesive tape
Rubber Base
Fastener
TV or rack
side view
Double-sided
adhesive tape
Rubber Base
