6
CONNECTIONS
z
Connect the screw-type input terminals at the rear of the speakers to the speaker output terminals of the
receiver.
z
Connect the (+) terminals on the receiver and speakers using the corresponding side of the cable. Connect
the (–) terminals on both components using the other side of the cable.
Notes:
z
Make sure that the bare wires are not touching each other as this could damage the speaker and receiver.
z
Connect one speaker to the left terminals of your receiver, and another speaker to the right terminals,
making sure not to reverse the polarity (+, –). If one speaker is connected with reversed polarity, the sound
will be unnatural and lack bass.
z
How to connect
1
Loosen the knob.
2
Insert the bare wire.
Remove the insulation
coating at the extremity of each speaker cable
by twisting the coating off.
3
Tighten the knob and secure the cable. Test the
firmness of the connection by pulling lightly on the
cable at the terminal.
z
When using a banana plug
1
Tighten the terminal knob.
2
Insert the banana plug into the terminal.
NS-IW360C
+ –
Receiver
Loosen
Red (+)
Black (–)
1
2
(–)
(+)
Tighten
3
1
2
Banana plug
