INSTALLATION
Before installation, check to ensure that the area you are installing the speaker is free of any wall studs, by
tapping the wall or using a stud finder.
If you wish to paint the speaker frame and grill, please refer to page 7 “PAINTING THE SPEAKER FRAME AND
GRILL” before proceeding.
Position the cutout template
where you are installing the
speaker. Make sure the
template is level, then trace
around the template with a
pencil.
1
TEMPLATE
Drill a pilot hole in the center
outline you traced.
2
Insert the bent coat hanger
wire into the hole. Then
slowly rotate to check for any
obstruction. If there is any
obstruction, patch the hole
and select another location.
3
360°
Cut the wall along the outline
you traced.
4
Run high quality speaker
cable from your receiver to
the speaker. Leave a few
extra feet of cable.
5
Note:
You can insulate the cavity by
placing a sheet of fiberglass
insulation around the speaker
components to improve
speaker performance.
4
