5
Placing the Speakers
Engli
s
h
• One speaker weighs about 1.0 kg (2 lbs 3 oz). To attach a speaker to a wall using screws, the wall must be firm. Do not attach a speaker
to a wall that is made of weak materials such as plaster or veneered woods. Doing so may cause the speaker to fall.
• Make sure you use specified screws to attach a speaker to a wall. Using clamps other than specified screws, such as short screws, nails,
or two-sided tape, may cause the speaker to fall.
• When connecting the speakers, fix the speaker cables in place so that cables do not loosen. If your foot or hand accidentally gets
caught on a loose speaker cable, the speaker may fall.
• After attaching each speaker, check that the speaker is fixed securely. YAMAHA will bear no responsibility for any accidents caused
by improper installations.
To mount on a speaker stand
You can mount the speakers on YAMAHA speaker stands “SPS-200” (set of two, optional) or commercially available
speaker brackets. When using commercially available speaker brackets, follow the procedure below to attach the supplied
mounting bracket to the speaker. When using YAMAHA speaker stands “SPS-200”, you do not need the following
procedure.
For information on how to mount a speaker on the speaker bracket, refer to the manual for the speaker brackets you want
to use.
YAMAHA speaker stand “SPS-200” (set of two, optional)
To mount a speaker on the YAMAHA speaker stand
“SPS-200”, refer to manual for the speaker stand.
* This product may not be available in certain regions.
For information, contact the store where you purchased
the product or your nearest YAMAHA dealer.
To attach to a bracket
1
Attach the mounting bracket to the speaker
using the supplied screw.
The jutting part of the bracket should fit to the groove
at the speaker base.
2
Mount the speaker on the speaker bracket
using the holes on the mounting bracket.
To mount a speaker on a commercially available
speaker bracket, you need two screws (Diameter:
4 mm (5/32”), spring washers, and washers. For more
information, refer to the manual for the speaker
bracket you want to use.
Notes
SPS-200
Mounting bracket
(supplied)
60 mm (2-3/8”)
Screw (supplied)
Summary of Contents for NS-P336
Page 1: ......
