9
En
Notes
• Make sure that the “+” and “–” polarity markings of the speaker cables are observed and set
correctly. If these cables are reversed, the sound will be unnatural and lack bass.
• Do not let the bare speaker wires touch each other, because this could damage the subwoofer
or the amplifier.
• If the connections are faulty, no sound will be heard from the subwoofer or the speakers. Do
not insert the insulation into the hole. Sound may not be produced.
• To avoid accidents resulting from tripping over loose speaker cables, fix them to the floor.
■
Before connecting
Remove the insulation at the tip of the speaker cable, then twist the core wires together so
that they will not become disarrayed and short-circuited.
Remove about 15 mm (5/8") of insulation.
Remove about 10 mm (3/8") of insulation.
■
How to connect
1.
Loosen the terminal’s knob, as shown in the figure.
2.
Insert the bare wire.
3.
Tighten the knob.
4.
Test the firmness of the connection by pulling lightly
on the cable at the terminal.
1.
Press and hold the terminal’s tab, as shown
in the figure.
2.
Insert the bare wire.
3.
Release your finger from the tab to allow it
to lock securely on the cable’s wire end.
4.
Test the firmness of the connection by
pulling lightly on the cable at the terminal.
Connecting to the INPUT1/OUTPUT terminals of the subwoofer
15 mm /
10 mm
Good
No Good
NS-SW300
NS-SW200
■
Connecting the banana plug
(NS-SW300 only)
1.
Tighten the terminal knob.
2.
Simply insert the banana plug into the terminal.
2
1
3
Red:
positive (+)
Black:
negative (
–
)
NS-SW300
2
1
NS-SW200
3
1
2
