SETTINGS
➤
Setup menu
En
53
BEAM settings
When “AUTO SETUP” in the “IntelliBeam” menu (p. 33) is used, recommended beam
settings are automatically applied by this unit. However, “HORIZONTAL ANGLE”,
“BEAM TRAVEL LENGTH”, “FOCAL LENGTH” (except “Center”), and “IMAGE
LOCATION” settings can later be fine-tuned.
Surround sound channel output can also be modified from the “BEAM” menu.
Adjust the horizontal angle of sound beams for each channel using test tones.
Adjust toward L (left) to move the direction of the output to the left and adjust toward R
(right) to move it to the right.
Item
Front L, Front R, Center. Surround L, Surround R
Control range
L90° to R90°
• Channels that cannot be configured are displayed in grey as settings are specified as indicated in
“Switching between audio output methods for surround playback” (p. 42).
Specify the distance that sound beams travel for each channel. The distance starts at
this unit, ends at the listening position, and includes refraction off a wall. The audio
delay is adjusted and sound from each channel arrives at the listening position
simultaneously.
Item
Front L, Front R, Center, Surround L, Surround R
Control range
0.3 m to 24.0 m (1.0 ft to 80.0 ft)
• Configure this setting only when you have adjusted “HORIZONTAL ANGLE”.
• Channels that cannot be configured are displayed in grey as settings are specified as indicated in
“Switching between audio output methods for surround playback” (p. 42).
HORIZONTAL ANGLE
SETUP MENU
➜
BEAM
➜
HORIZONTAL
ANGLE
Beam angle
Angle to
left
Angle to
right
Left
W
key:
Increase angle.
X
key:
Decrease angle.
Right
X
key:
Increase angle.
W
key:
Decrease angle.
BEAM TRAVEL LENGTH
SETUP MENU
➜
BEAM
➜
BEAM TRAVEL
LENGTH
The length of each
arrow indicates the
beam travel length.
