The Function Mode
36
P-120/P-120S
34
F5.3: Soft Pedal Effect Depth
.................................................................
This function sets the depth of the soft pedal effect. The effect depth range is from 1 to 5. A
setting of “1” produces minimum effect depth while a setting of “5” produces maximum effect
depth. Press the
[–/NO
▼
]
and
[+/YES
▲
]
buttons simultaneously to recall the default setting
of “3”.
F5.4: SUSTAIN PEDAL Type
....................................................................
F5.5: AUX PEDAL Type
............................................................................
Depending upon the pedal that is connected to the SUSTAIN PEDAL jack or AUX PEDAL
jack, the effect produced by operating the pedal (ON/OFF, dynamics, etc.) might be reversed.
If that is the case, use this setting to correct pedal operation. The setting range is from 1 to 2.
Press the
[–/NO
▼
]
and
[+/YES
▲
]
buttons simultaneously to recall the default setting of “1”.
• Make sure that the power is switched OFF when connecting or disconnecting the pedal.
• If the SUSTAIN PEDAL type is set to “2”, disconnecting the sustain pedal while the power is switched
on may leave the sustain active, causing notes to sustain indefinitely. In this case, switch the power
“OFF” then back “ON”.
The volume of the metronome sound can be changed. After selecting “
F6
”, use the
[–/NO
▼
]
and
[+/YES
▲
]
buttons to set the metronome volume as required. The volume range
is from 1 through 20. A setting of “1” produces minimum sound, while a setting of “20” pro-
duces maximum metronome volume. Press the
[–/NO
▼
]
and
[+/YES
▲
]
buttons simulta-
neously to recall the default setting “10”.
This function sets the volume at which a “canceled” part is played during preset song play-
back (see page 17 for information on the “preset song part cancel” function). Use the
[–/NO
▼
]
and
[+/YES
▲
]
buttons to set the volume as required. The volume range is from 0
through 20. A setting of “0” produces no sound, while a setting of “20” produces maximum
volume. Press the
[–/NO
▼
]
and
[+/YES
▲
]
buttons simultaneously to recall the default setting
“5”.
Adjust the part volume to a comfortable level to use the “canceled” part as a guide to play
along with. Set to “0” if you don’t want to hear the part.
■
SHORTCUT:
You can jump directly to the metronome functions by pressing the
[TEMPO/FUNCTION#]
button while holding the
METRONOME [START/
STOP]
button.
NOTE
F6
: Metronome Volume______________________________
F7
: Preset Song Part Cancel Volume __________________