30
P-250
Basic Operation
■
Performances
On the P-250, a “performance” refers to a group of settings that control the tone generator, MIDI, and so
on. You can recall any of 32 performances from the panel by pressing just one button.
The performances are divided into two banks (A and B). Performances in Bank A are called A01-A16, and
performances in Bank B are called B01-B16.
Refer to “Performance Operation” (page 41) for more information on recalling performances.
Performance parameters
Performance parameters are stored in a performance. You can edit these parameters and store them as a new performance.
Parameter menu
Parameter function
Parameter name on screen
Reference page
Name
Naming a performance
(Performance name)
Voice
Turning the reverb on/off
N/A
Setting Dual or Split mode
N/A
Selecting a voice
*1
N/A
[VOICE EDIT]
Setting the octave
*1
Octave
Setting the volume level
*1
Volume
Setting the position of left and right channels
*1
Pan
Adjusting fine pitch offset between two voices in Dual
mode
*2
Detune
Selecting the reverb type
ReverbType
Setting the reverb depth
*1
ReverbSend
Setting the chorus type
ChorusType
Setting the chorus depth
*1
ChorusSend
Turning the chorus on/off
*2
ChorusOnOff
Selecting the insertion effect type
*1
Ins.Type
Setting the speed of the vibraphone vibrato effect *1
VibeRotorSpeed
Turning the vibraphone vibrato on/off
*1
VibeRotorOnOff
Adjusting the speed of the rotary speaker
*1
RotarySpeed
Adjusting the insertion effect depth
*1
Dry/WetBalance
Adjusting the brightness of the sound
*1
Brightness
Adjusting the resonance effect
*1
HarmonicContent
Adjusting the low-range frequency of the part EQ
*1
EQ LowFreq.
Adjusting the high-range frequency of the part EQ
*1
EQ HighFreq.
Adjusting the low-range gain (amount of boost/cut) of
the part EQ
*1
EQ LowGain
Adjusting the high-range gain (amount of boost/cut) of
the part EQ
*1
EQ HighGain
Setting the touch sensitivity
*1
TouchSense
Assigening the Pedal 1 function
*2
Pedal 1
Assigening the Pedal 2 function
*2
Pedal 2
Assigening the Pedal 3 function
*2
Pedal 3
Assigening the Pedal 4 function
*2
Pedal 4
Assigening the modulation wheel function
*2
Modulation
Setting the MSB of the Send Bank Select message
*1
SendBankMSB
Setting the LSB of the Send Bank Select message
*1
SendBankLSB
Setting the Program Change message
*1
SendPG#
Turning the Internal tone generator on/off
*1
InternalTG
Summary of Contents for P-250
Page 56: ...MEMO 56 P 250 Edit Operation ...
Page 80: ...MEMO 80 P 250 Appendix ...