38
P-250
Basic Operation
■
Using the Master Equalizer
The five-band (LOW, LO-MID, MID, HI-MID,
HIGH) Master Equalizer enables you to adjust
the sound quality.
For example, you can enhance the high range
of the P-250 sound so that it will stand out
from an ensemble. Or, you can boost the lower
range to create a dynamic sound. Use the mas-
ter equalizer to suit the situation or to produce
a desired tonal color.
Raise or lower the MASTER EQUALIZER slid-
ers to boost or cut the corresponding fre-
quency band.
All parameters accessed via the [MASTER EQ EDIT]
button are performance parameters (page 30).
■
Using the Pitch Bend and
Modulation Wheels
You can apply real-time vibrato or a pitch bend
effect to a sound by using the pitch bend and
modulation wheels. Using these wheels will
increase the expressiveness of the sound, partic-
ularly in solo phrases.
Pitch bend wheel
Use the pitch bend wheel to bend notes up or
down while playing the keyboard to add a pitch
bend effect.
“PitchBendRange” is a performance parameter
(page 30).
Modulation wheel
You can apply vibrato effects to the sound, or change
the amount of reverb or modulation effects, by mov-
ing the modulation wheel up and down.
TIP
To set the master equalizer frequency and Q, use the
[MASTER EQ EDIT] button (page 71), which also enables
you to set the gain. However, the latest gain setting by the
sliders or [MASTER EQ EDIT] button will remain in effect.
TIP
The master equalizer is globally applied to the P-250 the
sound currently being played.
TIP
You can also access the channel equalizer via the [VOICE
EDIT] button. This equalizer enables you to adjust the
sound of each voice independently. (page 68)
TIP
When you set the “EqualizerLock” parameter (page 79),
which is accessed via the [OTHER SETTING] button, to
ON, the master equalizer settings will not be affected by
performance recall or MIDI song playback.
HIGH
HI-MID
MASTER EQUALIZER
LOW
LO-MID
MID
When the corresponding slider is set to center, the equal-
izer level is set to normal.
TIP
The pitch bend effect is applied only to the sound you are
playing on the keyboard.
TIP
To set the bend range, use the “PitchBendRange” parameter,
which is accessed by the [OTHER SETTING] button (page 79).
TIP
If you set the “PitchBendRange” parameter too high, high
notes may sound out of tune.
TIP
You can specify in Edit mode the effect you wish to control
with the modulation wheel (see page 69).
TIP
If you do not need to use the modulation wheel, you can
turn it off so that you will not activate it accidentally during
performance, or to avoid unnecessary transmission of MIDI
messages (see page 69).
TIP
The modulation wheel for some voices is disabled by
default. In that case, operating the wheel will have no effect,
unless you turn the wheel on.
MODULATION
PITCH
Summary of Contents for P-250
Page 56: ...MEMO 56 P 250 Edit Operation ...
Page 80: ...MEMO 80 P 250 Appendix ...