P-250
75
Edit Operation
■
Specifying the type of data received via MIDI
[ReceiveParameter]
This parameter enables you to specify the MIDI data type
the P-250 will receive.
Press the C [–]/[+] buttons to select the data type (Note,
Control, Program, AfterTouch, PitchBend, SysEx), and
press the D [–]/[+] buttons to specify On or Off.
■
Specifying the type of data transmitted via
MIDI [TransmitParameter]
This parameter enables you to specify the MIDI data type
the P-250 will transmit.
Press the C [–]/[+] buttons to select the data type: (Note,
Control, AfterTouch, Program, PitchBend, SystemReal-
Time, SysEx), then press the D [–]/[+] buttons to specify
On or Off.
■
Transmitting the initial settings on the panel
[InitialSetup]
You can transmit the panel data, such as voice selection,
to a connected sequencer. Before you record your play-
ing on the keyboard to a connected sequencer, it is use-
ful if you first send and record (at the beginning of your
recording) the panel setup data for your performance
during playback.
Press the B [+(YES)] button to start transmission.
■
Executing Voice Data Bulk Dump [VoiceBulk-
Dump]
You can transmit the voice data specified in the “VOICE
EDIT” menu (page 65) as MIDI bulk data.
Press the B [+] button to start the transmission.
You can interrupt voice data bulk dump transmission by
pressing the B [
–(
NO)] button.
• Refer to page 61 for general information on setting the parameters.
• Refer to pages 3—5 of the separate “Data List” for information on the
default parameter settings.
Summary of Contents for P-250
Page 56: ...MEMO 56 P 250 Edit Operation ...
Page 80: ...MEMO 80 P 250 Appendix ...