11
P-60/P-60S
9.
Assembling the GHD Keyboard
9-1
Hammer of White (Black) Key
Place the keyboard assembly upside down, insert a
hammer assembly into the frame, and put the
stopper L88W on. (Fig.15)
*
There are four kinds of hammers that differ in
weight.
9-2
Key Spring
Place the keyboard assembly right side up, and fix
a key spring to the frame by setting it at the slit
and pushing it down once. (Fig.16)
*
Be careful of the direction of the spring.
9-3
White (Black) Key
After a key has been fit to part [F] and the key
guide, make sure that the spring is fixed to the key.
Then press part [E] of the key down. (Fig.17)
9-4
GH-D_SW L circuit board.
Tighten the seven [7] screws marked [260a] to fix
the GH-D_SW L circuit board. (Fig.10)
9-5
GH-D_SW H circuit board.
Tighten the ten [10] screws marked [260b] to fix
the GH-D_SW H circuit board. Set the slits of the
rubber contact at the marks on the frame. (Fig.10)
(Fig. 15)
Hammer, White Key
Slit
Frame
Stopper L88W
Frame
Hook
Spring
Upside
(Fig. 16)
[E]
[F]
Whie Key
Key Guide
Key Spring
(Fig. 17)