Yamaha PCY100, Owner'S Manual

10

As shown in the diagram, set up your pad unit on an electronic drum rack or a standard cymbal stand 
(such as a Yamaha CS Series product). 

1

Using a tuning key (optional), loosen the stopper’s key bolt. (See Figure 1.)

2

Remove the wing nut, the two felt pads, and the bolt cover from the cymbal holder. (See Figure 2.)

3

Place the stopper on the cymbal holder. (See Figure 3.)

• If the key bolt was not sufficiently loosened in Step 1 above, it may not be possible to pass the 

stopper over the cymbal holder’s shaft. In such a case, loosen the key bolt as much as possi-
ble without removing it.

4

Replace the bolt cover. (See Figure 3.)

• When assembling the bolt cover, turn until it no longer rotates.

5

Secure the stopper in place. With the stopper making full contact with the bottom surface of the bolt 
cover, tighten the stopper’s key bolt using a tuning key. (See Figure 4.)

Setting Up

CAUTION

• If the clamp bolt and other fasteners are not sufficiently tightened, your pad unit may fall, 

possibly causing injury. It is important, therefore, that you mount your pad unit securely on 
the drum rack or stand. In addition, you should avoid placing your rack or stand on an 
uneven surface as this may cause it to fall over while being played, again increasing the risk 
of injury.

Key bolt

Stopper

Stopper

Tuning key

(optional)

[Figure 1]

[Figure 2]

[Figure 3]

Bolt cover

Cymbal 
holder

Bolt cover

Cymbal 
holder

Wing nut

Felt Pads

Stopper

[Figure 4]

Bolt cover

Full contact