53
DGX-630/YPG-635
This operation saves a user song (song numbers 031-035) to USB flash memory.
1
2
3
4
5
6
7
8
9
10
Saving a User Song to USB Flash Memory
To Overwrite an Existing File
If you want to overwrite a file that already exists
on the USB flash memory, use the dial or the
[+] and [-] buttons to select the file, then skip
ahead to step 7.
The source user song name.
The name of the file to
be saved
Cursor
•
Once the save-in-progress message appears on the display the
operation cannot be canceled. Never turn off the power or
remove the USB flash memory during this operation.
CAUTION
•
If an existing filename is specified the display prompts you for confir-
mation. Press [EXECUTE] or [+] if it is OK to overwrite the file, or [-]
to cancel.
•
The amount of time it will take to perform the save operation will
depend on the condition of the USB flash memory.
NOTE
•
Use the CATEGORY [ ] and [ ] buttons to
locate the User Song Save item.
Make sure that a properly formatted USB flash
memory has been properly connected to the
instrument's USB TO DEVICE terminal, and
that the icon is showing in the MAIN display.
Press the FILE CONTROL [MENU] button.
The DESTINATION SONG will be highlighted,
and a default name will automatically be created.
A cursor will appear below the first character in the
file name.
Refer to "Saving User Files (Registration Memory)
to USB Flash Memory" for filename entry.
Press the [EXECUTE] button. The display
prompts you for confirmation.
You can cancel the save operation at this point by
pressing the [-] button.
The SOURCE FILE-a user song name-will be
highlighted.
Select the source user song.
You can press the [+] and [-] buttons simulta-
neously to select the first user song.
Press the [EXECUTE] button.
Press the [EXECUTE] button.
Change the file name as necessary.
Press the [EXECUTE] button again, or the [+]
button, and the save operation will begin.
The user song will be stored to the USER FILE
folder in the USB flash memory.
A message will appear on the display to inform
you that the operation has finished.
Press the [EXIT] button to return to the MAIN
display.
