PSR-2000/1000
152
Using Your PSR-2000/1000 with Other Devices
1
Using the Headphones
(PHONES jack).
A standard pair of stereo headphones can be plugged in
here for private practice or late-night playing. The internal
stereo speaker system is automatically shut off when a
pair of headphones is plugged into the PHONES jack
(page 149).
2
Connecting the Microphone
or Guitar (MIC./LINE IN jack)
(PSR-2000 only).
By connecting a microphone to the PSR-2000, you can
enjoy singing along with your own performance or song
playback. (A dynamic microphone is recommended.) The
PSR-2000 outputs your vocals or guitar sounds through
the built-in speakers.
1
Connect your microphone to the MIC./LINE IN jack
(standard 1/4" phone jack).
2
Set the [MIC. LINE] switch (located next to the
[MIC./LINE IN] jack) to the MIC. position.
3
Use the
[INPUT VOLUME]
knob (located next to the
MIC./LINE IN jack) to set the
microphone volume then
trying singing into the
microphone.
The volume should be set high enough that the
SIGNAL lamp on the top panel lights steadily when
you sing, but not so high that the OVER lamp lights
(page 128).
Before connecting the PSR-2000/1000 to other electronic compo-
nents, turn off the power to all the components. Before turning the
power on or off to all components, set all volume levels to minimum
(0). Otherwise, electrical shock or damage to the components may
occur.
CAUTION
1
Use an unidirectional microphone for best results.
MIC. LINE
MIC. LINE
When connecting a microphone
When connecting a guitar
You should set the [MIC. LINE] switch to the LINE position when
connecting an audio source with line-level output to the MIC./LINE
IN jack.
INPUT
VOLUME
MIC./
LINE IN
L
R
AUX OUT
(LEVEL FIXED)
MIC. LINE
MIDI
HOST SELECT
FOOT PEDAL
OUT
2
IN
MIDI
PC2
PC1
Mac
TO HOST
DC IN 16V
R
L/L+R
OUTPUT
2
3
6
4
5