154
Reference
● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ●
MIDI Functions
MFC10 Settings
Various functions can be assigned to an optional Yamaha MFC10 MIDI Foot Controller
connected to the PSR-9000.
Connect the MFC10 to the MIDI B terminals and set the MIDI channel for the MFC10
messages by following the on-screen instructions.
The PSR-9000 provides two ways to set: Easy Setup and Full Setup.
The explanations here apply to step #5 of the Basic Procedure on page 150.
■
Easy Setup
Follow the on-screen instructions to call up the template display as shown below.
MIDI cable
MIDI OUT
MIDI IN
MIDI IN
MIDI OUT
PSR-9000
MFC10
MIDI B
IN
OUT
NEXT
BACK
PAGE CONTROL
Select a template.
Press the [NEXT] button to enable
the selected Easy Setup template.
Disconnect the MIDI cable from the
MIDI OUT B terminal and connect it
to the MFC10 Foot Controller.
• When the MIDI B terminals are
connected to the MFC10, the
functions of the MIDI B port are
limited. For details, refer to the
MIDI Data Format (page 192).
152
• When setting up the MFC10
from the PSR-9000, a MIDI
cable must be connected from
the MIDI OUT of the PSR-9000
to the MIDI IN of the MFC10.
However, you should discon-
nect this cable when using the
MFC10, since extraneous MIDI
messages may be transmitted
from the PSR-9000.
• To exit from the MFC10 play
mode, select the MIDI Tem-
plate display (page 150) and
press the [CANCEL] LCD but-
ton.
• The MFC10 play mode on/off
status is retained in Flash
ROM and is maintained even
when the power is turned off.
