PSR-A300
7
1.
Lower Case Assembly
(Time required: About 1 minute)
1-1
Remove the five (5) screws marked [240A], two (2)
screws marked [270A], and two (2) screws marked
[410]. The lower case assembly can then be
removed. (Fig. 1)
2.
DMLCD Circuit Board
(Time required: About 3 minutes)
2-1
Remove the lower case assembly. (See procedure 1)
2-2
Remove the eight (8) screws marked [240B]. The
DMLCD circuit board can then be removed. (Fig. 2)
∗
When installing the DMLCD circuit board, tighten
the screws 1 through 8 in numerical order. (Fig. 2)
∗
If the DMLCD circuit board is replaced, execute the
“Factory Set” in the test program.
3.
LCD
(Time required: About 3 minutes)
3-1
Remove the lower case assembly. (See procedure 1)
3-2
Remove the DMLCD circuit board. (See procedure 2)
3-3
Remove the LCD holder and rubber connector.
3-4
Remove the back light assembly. (Fig. 4)
3-5
Remove the LCD. (Fig. 4)
∗
When attaching the rubber connector, set the
conductive part to face inside. (Fig. 4)
[270A]
[240A]
[270A]
Speaker Grille L
Wheel
Speaker Grille R
Knob (Master Volume)
[240A]
[240A]
[410]
[410]
Bottom view
Top view
Battery Lid Assembly
Lower Case Keyboard Assembly
Lower Case Assembly
[240]: Bind Head Tapping Screw-B 3.0X12 MFZN2W3 (WE987400)
[270]: Bind Head Tapping Screw-B 3.0X30 MFZN2W3 (WF491000)
[410]: Bind Head Tapping Screw-B 3.0X20 MFZN2W3 (WF489300)
(Fig.1)
DISASSEMBLY PROCEDURE
Caution: Be sure to attach the removed filament tape just as it was before removal.
