PSR-E360 Owner’s Manual
12
Se
tt
in
g U
p
Power Requirements
Although the instrument will run either from an AC adaptor or batteries, Yamaha
recommends use of an AC adaptor whenever possible. An AC adaptor is more
environmentally friendly than batteries and does not deplete resources.
Using an AC Adaptor
Connect the AC adaptor in the order shown in the illustration.
Using Batteries
This instrument requires six “AA” size, Alkaline (LR6)/Manganese (R6) batter-
ies, or rechargeable nickel-metal hydride batteries (rechargeable Ni-MH batter-
ies). The Alkaline batteries or rechargeable Ni-MH batteries are recommended
for this instrument, since other types may result in poorer battery performance.
1
Make sure that the power of the instrument is off.
2
Open the battery compartment cover located on the instrument’s bottom
panel.
3
Insert the six new batteries, being
careful to follow the polarity mark-
ings on the inside of the compart-
ment.
4
Replace the compartment cover,
making sure that it locks firmly in
place.
• Use the specified AC adaptor (page 35) only. Using the wrong AC adaptor can result in
damage to the instrument or overheating.
• When using the AC adaptor with a remov-
able plug, make sure to keep the plug
attached to the AC adaptor. Using the
plug alone can cause electric shock or
fire.
• If the plug is accidentally removed from
the AC adaptor, slide it back in until it
clicks into place, taking care to avoid
touching any internal metal parts. To
avoid electric shock, short circuit or dam-
age, also be careful that there is no dust
between the AC adaptor and plug.
• When setting up the product, make sure that the AC outlet you are using is easily accessi-
ble. If some trouble or malfunction occurs, immediately turn the power off and disconnect
the plug from the outlet.
• Follow the order shown above in reverse when disconnecting the AC adaptor.
AC outlet
AC
adaptor
2
1
DC IN jack
(page 11)
WARNING
WARNING
Plug
The shape of the plug differs depending
on your area.
Slide the plug
as indicated.
CAUTION
NOTE
• When the batteries run out, or if the instrument is not to be used for a long time, remove
the batteries from the instrument.
• Connecting or disconnecting the power adaptor with batteries installed may turn the
power off, resulting in loss of data being recorded at the time.
• Make sure to set the battery type correctly (page 35).
• When battery power becomes too low for proper operation, the volume may be reduced,
the sound may be distorted, and other problems may occur. When this happens, make sure
to replace all batteries with new ones or already recharged ones.
WARNING
NOTICE
Setting Up
