PSR-S950/S750 Reference Manual
17
1
V
oices
2 DSP
3 EQ
Determines the Frequency and Gain of the Low and High EQ bands. For information about EQ, refer to
.
HARMONY Page
Same as in the [FUNCTION]
[H] HARMONY/ECHO display. See “Selecting the Harmony/Echo
.
Disabling Automatic Selection of Voice Sets (Effects, etc.)
Each Voice is linked to its default VOICE SET parameter settings. Usually these settings are automatically
called up when a Voice is selected. However, you can also disable this feature by the operation in the relevant
display as explained below. For example, if you want to change the Voice yet keep the same Harmony effect,
set the HARMONY/ECHO parameter to OFF (in the display explained below).
1
Call up the operation display.
[FUNCTION]
[E] REGIST SEQUENCE/FREEZE/VOICE SET
TAB [
E
][
F
] VOICE SET
2
Use the [A]/[B] buttons to select a keyboard part.
3
Use the [4
]–[7
] buttons to turn on or off of each item for the selected Part.
When the button is set to ON, the corresponding parameter settings are called up automatically together
with the Voice selection. For information on which parameters are linked to each item, see below.
[1
]–
[4
]
DSP TYPE
Selects the DSP effect category and type. Select a type after selecting a
category.
[5
]–
[8
]
VARIATION
Two variations are provided for each DSP type. Here, you can edit the
VARIATION on/off status and the variation’s parameter value setting.
[5
]
ON/OFF
Turns the DSP Variation on or off for the selected Voice. This setting
can also be made from the VOICE CONTROL [DSP VARI.] button on
the panel. (This button is effective only when the [DSP] button is on.)
PARAMETER
Displays the variation parameter. (This differs depending on the effect
type and cannot be changed.)
[6
]
–[8
]
VALUE
Adjusts the value of the DSP variation parameter.
2
3
