9-21
9
5. Remove the coolant reservoir cap.
6. Disconnect the coolant reservoir hose on the
coolant reservoir side, and then drain the
coolant from the coolant reservoir.
7. After draining the coolant, thoroughly flush
the cooling system with clean tap water.
8. Install the coolant drain bolt and its new gas-
ket, and then tighten the bolt to the specified
torque.
9. Connect the coolant reservoir hose.
10. Pour the recommended coolant into the res-
ervoir to the maximum level mark, and then
install the reservoir cap.
11. Pour the recommended coolant into the radi-
ator until it is full, and then install the radiator
cap.
12. Start the engine, let it idle for several minutes,
and then turn it off.
TIP
While the engine is idling, check the cooling sys-
tem for leaks.
13. When the engine is cool, remove the radiator
cap to check the coolant level in the radiator.
If it is low, add sufficient coolant until it reach-
es the top of the radiator, and then install the
radiator cap.
14. Install the panel.
EBU2680B
Cleaning the air filter element
The air filter element should be cleaned at the in-
tervals specified in the periodic maintenance
chart. Clean or, if necessary, replace the air filter
element more frequently if you are riding in unusu-
ally wet or dusty areas.
1. Coolant reservoir cap
2. Coolant reservoir hose
Tightening torque:
Coolant drain bolt:
11 N·m (1.1 kgf·m, 8.1 lb·ft)
1
2
UBCX12E0.book Page 21 Friday, November 5, 2021 11:45 AM
