29
- Antenna. The only icon guaranteed to be in this box. If it is blinking, an
antenna is not communicating with the Base DSP unit. If it is solid,
communication is passing between the Antenna and Base.
- Wired Sync. If a wired sync buss is being used to sync clocks between
Executive systems, the synced Elites will show this icon. Remember that sync
mode must be set before the base will look for an external clock.
- AVB. When AVB is plugged into the Base, the “AVB” icon will appear.
Until the Base is set up as a “talker” or “listener”, the arrows above or below
“AVB” will not appear. To check if the Base is set up for either, remember “T”
is for talker and “L” is for listener.
- This symbol is only used in Japanese markets and indicates that a PHS
(Personal Handyphone System) system is detected in the vicinity of the
Executibve Elite Antenna. If such a system is detected, several of the DECT
carrier frequencies are reserved for PHS and cannot be used for Executive Elite
microphones. The maximum density of microphones is therefore reduced in
these environments.
Separated from the external systems box by a vertical line is the channel
information section of the Front Panel UI. At the top, each channel is labeled,
and two rows underneath provide different information depending on which
home screen is currently selected.
On all screens, the top row will show microphone status beyond linked with the
following icons:
- Microphone Lost Link, or Unknown Status Microphone
- Firmware Update in Process
- Stand-by Mode
Microphone channels that have no microphone paired, a charging microphone,
or when the microphone is switched off, will show no information.
Additional information from this row can be found in the following symbols: