Mics Unmute at Startup:
By default the mics go into a muted state when they are removed from the charger. This is done to
prevent handling noise as the microphone is placed into position. By selecting ‘Mics Unmuted at
Startup’, the mics will go into an unmuted state when removed from the charger.
All Mic Mute:
This feature removes the mics individual mute capability and causes both microphones to mute when
the mute button on either microphone is pressed. The same effect will take place when unmuting the
microphones.
Note:
Any changes to ‘Mics Unmute at Startup’ or ‘All Mic Mute’ requires the ‘Save’ button to be
pressed in order for the changes to take effect.
Lock:
Each microphone has individual lock capabilities. By turning on the lock for a specific microphone, the
microphone mute button will deactivate leaving the user without the ability to individually control the
microphones mute status at the microphone. However, the HD Control Panel Software will still have
the ability to control and monitor all locked microphones.
Note:
A microphone lock is stored in the Base Station. If a new microphone is paired to a locked
channel, that microphone will then be locked as well. The same goes for a locked microphone that is
paired to an unlocked channel, that microphone will then be unlocked.
Mute:
Each microphone has individual mute capabilities. The HD Control Panel Software provides the user
the ability to mute and unmute a microphone from their PC. These mute controls will always remain
synchronized to the actual state of the microphone. If the microphone state is changed at the
microphone, the mute controls will display that change.
Gain:
Each microphone has an individual gain fader. This fader pr/- 10dB of gain in 5dB
increments. The microphone gains are stored in the Base Station and will be applied to any
microphone paired to that channel.
Status:
This provides the current status for the microphone paired to each channel. The status can read any
of the following states:
Type:
This provides the current type for the microphone that is paired to each channel.
Version:
This provides the current firmware version for the microphone that is paired to each channel.
OFF = Microphone is has been turned off
ON = Microphone is on and operational
CHRG = Microphone is in the Charging Base
OUT = Microphone is out of range and cannot communicate
13
