Pre-Flight Inspection Items
3-9
GPS Indicator Light (Orange)
The GPS indicator lights (orange) illuminates or flashes to inform the operator of the reception conditions of
the GPS signals and the state of GPS control.
Take the appropriate actions in accordance with the description of the warning.
Condition
Indication
Meaning
Action
Before
starting
engine
All OFF
Preparing GPS control set-
tings (awaiting completion of
YACS control configuration)
Wait until the completion of YACS control
configuration (when all YACS warning lights
turn OFF).
If the outer lights do not flash after the
YACS control configuration has completed,
there may be an equipment failure.
Only outer lights flash
GPS control is being config-
ured.
GPS control is being prepared. Fly the heli-
copter by using only YACS control or wait
for the GPS control configuration to com-
plete (the outer lights illuminate).
If the outer lights do not illuminate after 3
minutes, the GPS signal reception might be
poor. Therefore, fly the helicopter by using
only YACS control.
Only outer lights are ON
(all lights illuminate with
GPS control switch ON)
GPS control configuration is
complete.
The GPS control settings have been com-
pleted and the GPS control is for use.
Turn the GPS control switch ON and check
that all the lights are lit.
RMAX.book Page 9 Tuesday, January 17, 2012 3:06 PM
Summary of Contents for RMAX Type II G Unit
Page 4: ......
Page 22: ...Part Names 2 5 ...
Page 40: ...Pre Flight Inspection Items 3 17 ...
