Flying Procedure
5-4
5
The SETTING light on the check point indicator
flashes approximately 3 times (for 10 seconds),
and the system performs YACS control configu-
ration and self checks.
Check that all the red YACS warning lights on the
back of the helicopter illuminate during configuration.
If there are no problems, the
“
”
light of the
flight indicator will illuminate, indicating that the
YACS control configuration has completed.
6
After the YACS control configuration has com-
pleted and the YACS warning light has turned
OFF, the outer lights of the GPS indicator will
flash and the GPS control configuration will start.
•
The outer GPS indicator lights will flash while
GPS control is being configured.
•
The outer GPS indicator lights will change from
flashing to constant illumination when the GPS
control configuration has completed (which
take about 3 minutes).
•
After the lights illuminate, turn ON the GPS
control switch on the transmitter. Then, check
that all the GPS indicator lights illuminate.
•
After checking that all lights illuminate, turn
OFF the GPS control switch.
●
Do not move the helicopter while the
“
” light is flashing.
●
Configuring the YACS control with the heli-
copter tilted could cause errors. Therefore,
it is recommended to select a flat area for
this purpose.
●
If the “
” light illuminates on the flight
indicator, first turn the main switch OFF;
then, turn it to START. If the “
” light
illuminates again or if the “
” light
continues to flash, contact your dealer for
repair.
TIP
5
●
Step
5
completes the pre-start checks if
you will not be using GPS control or if you
will be using it later during the flight.
●
The length of time it takes to complete the
GPS control configuration varies accord-
ing to GPS signal reception. If it takes too
long (the lights do not illuminate after 3
minutes), you will not be able to use GPS
control in the AG, CG, or SG mode. Oper-
ate the helicopter under YACS control until
the signal reception improves, which will
be indicated by the illumination of the
outer lights.
TIP
OFF
ON
Outer lights flashing
(configuration in progress)
(After approximately
3 minutes)
Outer lights illuminating
(configuration complete)
GPS Control Switch
ON
All lights illuminating
RMAX.book Page 4 Tuesday, January 17, 2012 3:06 PM
Summary of Contents for RMAX Type II G Unit
Page 4: ......
Page 22: ...Part Names 2 5 ...
Page 40: ...Pre Flight Inspection Items 3 17 ...