RX-E400
32
RX-E400
Remarks
Remarks
Remarks
DIMMER level signal transmitted
about 1 second later
POWER SW OFF
[POFF_REQ]
[POFF_OK]
[POFF_OK]
Secondary connection state
[STATE_ON]
POWER SW ON
RX
CDX
MDX
KX
Secondary connection state
CDX
MDX
KX
or [STATE_OFF]
POWER SW ON
AC outlet ON
RX
[DIMM_*]
CDX
RX
MDX
KX
[STATE_ON]
or [STATE_OFF]
[STATE_ON]
Secondary connection state
Secondary connection state
Secondary connection state
[STATE_ON]
or [STATE_OFF]
[STATE_ON]
Secondary connection state
[STATE_ON]
or [STATE_OFF]
Secondary connection state
[STATE_ON]
or [STATE_OFF]
The relay turns off after
confirming [POFF_OK] of all the
units being connected.
After POWER OFFprocessing
After POWER OFFprocessing
[POFF_OK]
After POWER OFFprocessing
or [STATE_OFF]
( 1 ) POWER ON PROCESSING ( Receiver )
(2)POWER ON PROCESSING (except receiver)
(3)POWER OFF PROCESSING (Receiver)
When the power is turned on at a unit other than the receiver, the unit informs the receiver of the
status then.
When the power is turned on at the receiver, the relay of the AC outlet is turned on to supply
power to each unit.
Each unit informs the receiver of its status when started (secondary connection status).
The receiver turns off the AC outlet when the power off processing of each unit has been
completed.
The receiver detects
the units being
connected when
informed of the
secondary
connection state.
The receiver detects
the units being
connected when
informed of the
secondary
connection state.
The receiver detects
the units being
connected when
informed of the
secondary
connection state.
MD transmits
[POFF_OK] after TOC
writing has been
completed.
The indicator of each
unit turns on when
[DIMM_*] is received
but 2 seconds later
when the unit is
used alone.
