RX-V3200/DSP-AX3200
RX-V3200/DSP-AX3200
F
I
L
H
H
L
Fig. 4
8. Removal of VIDEO (1), VIDEO (2), VIDEO (4) and VIDEO (8)
P.C.B.s and Tuner*
1
a. Remove 17 screws (
H
). (Fig. 4)
(DSP-AX3200: 14 screws)
b. Remove VIDEO (1), VIDEO (2), VIDEO (4) and VIDEO (8)
P.C.B.s and the Tuner*
1
. (Fig. 5)
*
1
: RX-V3200 only
When checking the P.C.B.:
• Put the rubber sheet and a cloth over the equipment. Then
place the P.C.B. upside down on the cloth and check it. (Fig. 5)
• Connect VIDEO (5) and FUNCTION P.C.B.s by using the
extension cable (AAX30610) for the P.C.B. check. (Fig. 5)
• Reconnect all cables (connectors) that have been
disconnected.
• The P.C.B. removed from the rear panel does not work
because its grounding is loose. Be sure to connect the
ground of each P.C.B. to the chassis or GND with a jumper
wire or the like.
G
C
C
C
C
E
D
D
VIDEO (5) P.C.B.
DSP P.C.B.
Bracket
Support
10
Fig. 3
6. Removal of DSP P.C.B.
a. Remove 10 screws (
C
) and then remove the Bracket.
(Fig. 3)
b. Remove 2 screws (
D
) and then remove the Support.
(Fig. 3)
c. Remove 1 screw (
E
). (Fig. 3)
d. Remove 9 screw (
F
). (Fig. 4)
e. Remove the DSP P.C.B.. (Fig. 3)
7. Removal of VIDEO (5) P.C.B.
a. Remove 2 screws (
G
). (Fig. 3)
b. Remove the VIDEO (5) P.C.B. which is connected
directly to the lower P.C.B. with connectors. (Fig. 3)
Fig. 5
Extension cable
(AAX30610)
VIDEO (8) P.C.B.
VIDEO (5) P.C.B.
VIDEO (4)
P.C.B.
VIDEO (2) P.C.B.
VIDEO (1) P.C.B.
Tuner (RX-
V3200 only)
Rubber sheet
and cloth
