RX-V3200/DSP-AX3200
RX-V3200/DSP-AX3200
31
YS1-3
: Indicates device status information of YSS938 (IC514). * The numeric value in the figure is an example for
reference.
Byte No.
Function
1
YSS MUTE Reg
2
YSS MODE Reg
3
YSS IPORT BIT 7-0
4
YSS IPORT BIT 14-8
5
YSS OPORT
Byte No.
Function
1
IEC 1937 Preamble Pc
2
Data Stream Reg
3
Status Reg
4
YSS ZERO Reg
5
MIREG
Byte No.
Function
1
DIR Status
2
DIR fs
3
DIR fs count
4
YSS ZEROBF
CS1-5
: Indicates channel status information of the input signal (IEC60958).
BY1-4
: Indicates information of the bit stream included in the DOLBY DIGITAL signal.
BC1-4
: Indicates information of the bit stream included in the dts signal.
Display
Description
WAIT
Bus is being checked.
NoEr
No error detected.
DATA
Data bus shorted or open.
RSCS
/RAS or /CAS shorted, or open.
ADDR
Address bus shorted or open.
15. DSP RAM CHECK
This menu is used to self-diagnose whether or not the bus connection for the YSS938 and the external RAM is made
properly.
During signal processing, the status before execution of this menu is maintained.
The address bus and the data bus are checked and the connection condition is displayed.
When no error is detected, "NoEr" appears on display.
CS
: CS49329 Unsolicited Messages (AUTODETECT_RESPONSE)
MTT
: Mute Trigger
Byte No.
Function
1
Mute condition
2
Factor of the last mute
3
Error count of YSS938-FSCNT
4
Mute count by YSS938-FSCNT
5
Error factor of down load of CS49329
YSS938 Bus Check
<5th byte> Signal processing status information
*2: With digital signals other than 32kHz, 44.1kHz and 48kHz,
through processing method is used for reproducible signals.
bit7
MUTE request
bit3
–
bit6
Red dts flashing
bit2 Through & bypass (*2)
bit5
6.1ch. field being processed
bit1
–
bit4
FULL MUTE (ON: 1)
bit0
dts analog mute
