PREPARATIONS
➤
Connecting speakers
En
15
■
Connecting speaker cables
Speaker cables have two wires. One is for connecting the negative (-) terminal of the
unit and the speaker, and the other is for the positive (+) terminal. If the wires are
colored to prevent confusion, connect the black wire to the negative and the other wire
to the positive terminal.
a
Remove approximately 10 mm (3/8”) of insulation from the ends of the speaker cable and
twist the bare wires of the cable firmly together.
b
Loosen the speaker terminal.
c
Insert the bare wires of the cable into the gap on the side (upper right or bottom left) of the
terminal.
d
Tighten the terminal.
Using a banana plug
(Australia model only)
a
Tighten the speaker terminal.
b
Insert a banana plug into the end of the terminal.
■
Connecting the subwoofer (with built-in amplifier)
Use an audio pin cable to connect the subwoofer.
FR
ONT
a
a
b
d
c
+ (red)
- (black)
FRO
NT
a
b
Banana plug
PRE OUT
SUBWOOFER
AUDIO
MONITOR OUT
Y
A
V
OUT
A
V
6
Audio pin cable
1 2
Speaker connections
3 4 5 6 7 8 9 10
