PREPARATIONS
➤
Optimizing the speaker settings automatically (YPAO)
En
32
Error messages
If any error message is displayed during the measurement, resolve the problem and perform YPAO again.
TV screen
Front display
■
Procedure to handle errors
1
Check the content of error message and
press ENTER.
2
Use the cursor keys (
e
/
r
) to select the
desired operation.
To exit the YPAO measurement:
a
Select “EXIT” and press E
N
TER.
b
Use the cursor keys (
q
/
w
) to select “Exit” and press
E
N
TER.
c
Disconnect the YPAO microphone from the unit.
To retry the YPAO measurement from
beginning:
Select “RETRY” and press E
N
TER.
To proceed with the current YPAO
measurement (for E-5 and E-9 only):
Select “PROCEED” and press E
N
TER.
Error
message
A u t o S e t u p
S t a r t
E x i t
ERROR
E-5:Noisy
PROCEED
5 %
VOL.
SW
L
SL
C
SR
R
E-5:NOISY
• Texts in parentheses denote indicators on the front display.
Error message
Cause
Remedy
E-1:No Front SP
(E-1:NO FRNT SP)
Front speakers are not detected.
Exit YPAO, turn off the unit, and then check the speaker
connections.
E-2:No Sur. SP
(E-2:NO SUR SP)
One of the surround speakers cannot be
detected.
E-5:Noisy
(E-5:NOISY)
The noise is too loud.
Keep the room quiet and retry YPAO. If you select
“PROCEED”, YPAO takes the measurement again and
ignores any noise detected.
E-7:No MIC
(E-7:NO MIC)
The YPAO microphone has been removed.
Connect the YPAO microphone to the YPAO MIC jack firmly
and retry YPAO.
E-
8
:No Signal
(E-
8
:NO SIGNAL)
The YPAO microphone cannot detect test
tones.
Connect the YPAO microphone to the YPAO MIC jack firmly
and retry YPAO. If this error occurs repeatedly, contact the
nearest authorized Yamaha dealer or service center.
E-9:User Cancel
(E-9:CANCEL)
The measurement has been canceled.
Retry or exit YPAO as necessary.
E-10:Internal Err.
(E-10:INTERNAL)
An internal error has occurred.
Exit YPAO, and turn off and on the unit. If this error occurs
repeatedly, contact the nearest authorized Yamaha dealer or
service center.
1 2 3 4 5 6 7 8 9 10
Automatic speaker setup
