Graphical user interface (GUI) menu
100
En
Surround (Surround left/right speakers)
y
See page 23 for the connection information of the surround speakers.
Surround Back
(Surround back left/right speakers)
y
See page 23 for the connection information of the surround speakers.
Cross Over (Cross over)
Use this feature to select the crossover frequency of the speaker(s)
that is set to “Small”. All frequencies below the selected frequency
will be sent to the subwoofers or to the speakers set to “Large” in
“Speaker Set” (see pages 99).
Choices: 40Hz, 60Hz,
, 90Hz, 100Hz, 110Hz, 120Hz,
160Hz, 200Hz
y
If your subwoofers can adjust the output volume and the crossover
frequency, set the volume to about half way (or slightly less) and set the
crossover frequency to the maximum.
Front Presence (Front presence speakers)
Use this feature if you want to use the front presence speakers
connected to this unit.
• If you set “Front Presence” to “None”, you cannot activate the CINEMA
DSP HD³ mode (see page 64).
• “Dialogue Lift” is available when “Front Presence” is set to “Yes” and
headphones are not connected.
Rear Presence (Rear presence speakers)
Use this feature if you want to use the rear presence speakers
connected to this unit.
Subwoofer (Subwoofer)
Configuration (Subwoofer configuration)
Use this feature to select the configuration of the subwoofers
(see page 26).
y
If your subwoofer can adjust the output volume and the crossover
frequency, set the volume to about half way (or slightly less) and set
the crossover frequency to the maximum.
Choice
Descriptions
Select this setting when the center speaker is large.
Select this setting when the center speaker is small.
Select this setting when you do not use the center
speaker. The center channel signals are directed to the
front left and right speakers.
Choice
Descriptions
Select this setting when the surround speakers are large.
Select this setting when the surround speakers are small.
Select this setting when you do not use the surround
speakers. This unit is set to the Virtual CINEMA DSP
mode (see page 64), and “Surround Back” is
automatically set to “None”.
Choice
Descriptions
Select this setting when the single surround back speaker
is large.
Select this setting when the surround back left and right
speakers are Large.
Select this setting when the single surround back speaker
is small.
Select this setting when the surround back left and right
speakers are small.
Select this setting when you do not use the surround
back speakers. The surround back channel signals are
directed to the surround left and right speakers.
Choice
Descriptions
Select this setting when you use the front presence
speakers.
Select this setting when you do not use the front
presence speakers. “Rear Presence” is automatically set
to “None”.
Notes
Choice
Descriptions
Select this setting when you use the rear presence
speakers.
Select this setting when you do not use the rear presence
speakers.
Choice
Descriptions
Select this setting when you place the subwoofers to
the front and rear of the listening room.
Select this setting when you place the subwoofers to
the left and right of the listening room.
Select this setting when you use a single subwoofer.
Select this setting when you do not use a subwoofer.
