Graphical user interface (GUI) menu
101
En
Ad
v
a
nce
d
Op
eratio
n
Phase (Subwoofer phase)
Use this feature to switch the phase of your subwoofers if bass
sounds are lacking or unclear.
Bass Out (Bass out)
Use this feature to select the speakers that output the LFE (low-
frequency effect) and the low-frequency signals.
THX Ltd. recommends that “Bass Out” to “SWFR”.
LFE signals output
Low-frequency signals output
*1 Output(s) the low-frequency signals of the front channels and other
speakers set to “Small”.
*2 Always output the low-frequency signals of the front channels.
*3 Output the low-frequency signals if the speakers are set to “Large”.
*4 Outputs the low-frequency signals of the speakers set to “Small” or
■
Speaker Distance (Speaker distance)
Use this feature to manually adjust the distance of each speaker and the
delay applied to the respective channel. Ideally, each speaker should be
the same distance from the main listening position. However, this is not
possible in most home situations. Thus, a certain amount of delay must
be applied to the sound from each speaker so that all sounds will arrive
at the listening position at the same time.
Speaker distances
Control range: 0.30 to 24.00 m (1.0 to 80.0 ft)
Initial setting: 3.00 m (10.0 ft)
Control step: 0.05 m (0.2 ft)
y
If your subwoofer can adjust the output volume and the crossover frequency,
set the volume to about half way (or slightly less) and set the crossover
frequency to the maximum.
• The available speaker channels differ depending on the setting of the
speakers.
• If you are only using one surround back speaker, connect it to the
SUR.BACK SINGLE jack, and adjust the distance in “Surround Back L”.
Selects the unit for displaying the values of “Speaker Distance”
parameter.
Initial setting: Feet (U.S.A. and Canada models)
Meter (Other models)
Choice
Functions
Does not change the phase of your subwoofers.
Sets the phase of the left (or front) subwoofer to
reverse.
Sets the phase of the right (or rear) subwoofer to
reverse.
Sets the phase of the both subwoofers to reverse.
Choice
Subwoofers and speakers
Subwoofers
Front
speakers
Other
speakers
Output
No output
No output
Output
No output
No output
No output
Output
No output
Choice
Subwoofers and speakers
Subwoofers
Front
speakers
Other
speakers
*1
*2
*3
*4
*3
*3
No output
*1
*3
Speaker Distance
Adjusted speaker
Front left speaker
Front right speaker
Center speaker
Surround left speaker
Surround right speaker
Surround back left speaker
Surround back right speaker
Front presence left speaker
Front presence right speaker
Rear presence left speaker
Rear presence right speaker
Subwoofer left
Subwoofer right
Notes
Choice
Functions
Meter (m)
Adjusts speaker distances in meters.
Adjusts speaker distances in feet.
