Graphical user interface (GUI) menu
102
En
■
Speaker Level (Speaker level)
Use this feature to manually balance the speaker levels between the
front left or surround left speakers and each speaker selected in
“Speaker Set” (see page 99).
Control range: –10.0 dB to +10.0 dB
Initial setting: 0.0 dB
Control step: 0.5 dB
y
• If your subwoofer can adjust the output volume and the crossover
frequency, set the volume to about half way (or slightly less) and set the
crossover frequency to the maximum.
• If you use a handheld sound pressure level meter, hold at arm’s length and
point upwards so that the meter is in the listening position. With the meter
set to the 70 dB scale and to C SLOW, calibrate each speaker to 75 dB.
• The available speaker channels differ depending on the setting of the
speakers.
• If you are only using one surround back speaker, connect it to the
SUR.BACK SINGLE jack, and adjust the balance in “Surround Back L”.
• The setting of “Speaker Level” changes depending on the setting of “PEQ
Select” in “Manual Setup” (see page 104).
Use this menu to manually adjust the various volume settings.
Adaptive DRC (Adaptive dynamic range control)
Use this feature to adjust the dynamic range in conjunction with the
volume level. This feature is useful when you are listening at lower
volumes or at night. When “Adaptive DRC” is set to “Auto”, this
unit controls the dynamic range as follows:
– If the VOLUME setting is low: the dynamic range is narrow
– If the VOLUME setting is high: the dynamic range is wide
y
• You can also adjust the dynamic range of the bitstream signal sources by
using “Dynamic Range” in “Sound” (see page 103).
• This function is also useful for listening with your headphones.
• The adaptive dynamic range control feature does not function when this
unit is in the THX Surround modes (see page 87) or Pure Direct mode (see
page 65).
• If you set “Direct” in “2ch Stereo” to “Auto” (see page 94) and this unit is
in the 2ch Stereo mode, the adaptive dynamic range control feature does
not function in some cases.
Adaptive DSP Lvl (Adaptive DSP effect level)
Use this feature to make fine adjustments of the DSP effect level
(see page 91) automatically in conjunction with the volume level.
Even if you set “Adaptive DSP Lvl” to “Auto”, this unit does not change but
fine-tunes the specified value of “DSP Level” (see page 91).
Max Volume (Maximum volume)
Use this feature to set the maximum volume level in the main zone.
This feature is useful to avoid the unexpected loud sound by mistake.
For example, the original volume range is –80.0 dB to +16.5 dB.
However, when “Max Volume” is set to –5.0 dB, the volume range
becomes –80.0 dB to –5.0 dB.
Control range: –30.0 dB to +15.0 dB, +
16.5 dB
Control step: 5.0 dB
Speaker Level
Adjusted speaker
Front left speaker
Front right speaker
Center speaker
Surround left speaker
Surround right speaker
Surround back left speaker
Surround back right speaker
Front presence left speaker
Front presence right speaker
Rear presence left speaker
Rear presence right speaker
Subwoofer left
Subwoofer right
Notes
Choice
Functions
Adjusts the dynamic range automatically.
Does not adjust the dynamic range automatically.
Notes
Choice
Functions
Adjusts the DSP effect level in conjunction with the
volume level.
Does not adjust the DSP effect level automatically.
Note
Input level
Output
le
v
el
Output
le
v
el
Input level
AUTO
OFF
AUTO
OFF
VOLUME: low
VOLUME: high
