Graphical user interface (GUI) menu
114
En
■
Trigger Output (Trigger output)
Use this feature to select the functions of each TRIGGER OUT jack
of this unit.
Trigger operation mode
Source (Source)
After selecting the input source, you can set the function of the
TRIGGER OUT jacks when the corresponding input source is
selected.
Manual (Manual)
You can display the format, sampling frequency, channel, bit rate
and flag data of the current input signal.
■
Audio Info. (Audio information)
• “–––” appears when this unit cannot display the corresponding
information.
• Some high definition audio bitstream contents may not include the discrete
surround back left and right channel signals but are encoded at the bitrate
of 192 kHz.
• Even if you make settings to output bitstreams directly, some players
convert the Dolby TrueHD or Dolby Digital Plus bitstreams to the Dolby
Digital bitstreams, while converting the DTS-HD Master Audio or DTS-
HD High Resolution Audio bitstreams to the DTS bitstreams.
■
Video Info. (Video information)
HDMI error and message
Use this feature to select the language of the menu items and
messages.
Choices:
(English),
(Japanese),
Français (French), Deutsch (German),
Español (Spanish),
y
You can also select the language using the “LANGUAGE” parameter in
“Advanced setup” in the front panel display (see page 144).
··· The selected language is displayed.
— ··· The selected language is not displayed. The menu items and
messages are displayed in English.
Choice
Function
Sets the functions for the TRIGGER OUT 1 jack.
Sets the functions for the TRIGGER OUT 2 jack.
Choice
Descriptions
Select this setting to send the voltage signals at the
selected TRIGGER OUT jack while the selected zone is
turned on.
Select this setting to send the voltage signals at the
selected TRIGGER OUT jack while the selected input
source is selected.
Select this setting to send the voltage signals manually.
Choice
Descriptions
Sends the voltage when you select the input source
you set in “Source”.
Stops sending the voltage when you select the input
source you set in “Source”.
Choice
Function
Sends the voltage signals.
Stops sending the voltage signals.
Signal Info.
(Input signal information)
Signal format. When this unit cannot detect a digital
signal, it automatically switches to analog input.
The number of samples per second taken from a
continuous signal to make a discrete signal.
The number of source channels in the input signal
(front/surround/LFE). For example, a multi-channel
soundtrack with 3 front channels, 2 surround channels
and LFE, is displayed as “3/2/0.1”.
The number of bits passing a given point per second.
The dialogue normalization level preset to the current
input bitstream signal (see page 159).
Flag data encoded in the bitstream, or PCM signals that
cue this unit to automatically switch decoders
(“Surround EX”, etc.).
Notes
Type of the source video signals and the
video signals output at the HDMI OUT jack
of this unit.
Resolution of the input signal (analog or
HDMI) and the output signal (HDMI).
Resolution of the source video signals and
the analog video signals output at the
COMPONENT MONITOR OUT jacks of
this unit.
Error message for HDMI sources or
connected HDMI devices. See page 150 for
details.
Message
Cause
The number of the connected HDMI components
is over the limit.
HDCP authentication failed.
The connected monitor is not compatible with the
resolution of the input video signal.
GUI menu
Front panel
display
Русский
(Russian)
—
(Japanese)
—
—
Other languages
