Saving and recalling the system settings (System Memory)
115
En
Ad
v
a
nce
d
Op
eratio
n
Use this feature to save and recall up to 10 of your favorite setting
for the main zone. You can also save up to four of your favorite
settings for Zone 2, Zone 3, or Zone 4.
■
Saving by the
7
SYSTEM MEMORY
buttons
You can save the current system settings stored in “Memory1” to
“Memory4” by pressing the corresponding
7
SYSTEM MEMORY
buttons.
Press and hold one of the
7
SYSTEM MEMORY
buttons on the remote control for 4 seconds.
“MEMORY 1 SAVE” (example) appears in the front panel display,
and then this unit saves the current system setting to the
corresponding memory number.
• If system settings are already saved in the selected memory number, this
unit overwrites the old system settings.
• To save the system settings for Zone 2, Zone 3, or Zone 4, press
H
ZONE
on the remote control repeatedly to select the operation zone setting of the
remote control and then press and hold the desired
7
SYSTEM
MEMORY
button for 4 seconds. You can save the system settings for the
selected Zone only when the zone is turned on.
• This unit saves the parameters in the groups you select by using the GUI
menu when you save the parameters by using the
7
SYSTEM MEMORY
buttons.
■
Saving by the GUI menu operation
You can save the current system settings stored in “Memory1” to
“Memory10” by using the “System Memory” menu in the GUI
menu.
1
Press
I
MENU
on the remote control.
The top menu appears in the video monitor.
2
Press
9
k
/
n
repeatedly to select “System Memory”
and then press
9
h
.
The “System Memory” menu appears in the video monitor.
3
Press
9
k
/
n
repeatedly to select the desired zone
and then press
9
h
.
In the following example, you select “Main” (main zone). The
list of the memory number appears in the video monitor.
4
Press
9
k
/
n
repeatedly to select “Main Save” and
then press
9
h
.
The following menu appears in the video monitor.
5
Press
9
k
/
n
repeatedly to select the desired
memory number (“Memory1” to “Memory10” or
“Memory4”) and then press
9
h
.
The list of the saved items appears in the video monitor.
Saving and recalling the system settings (System Memory)
Saving the current system settings
Before performing the following operations, set the operation mode
selector on the remote control to
F
AMP
.
Notes
4
3
SYSTEM MEMORY
2
1
✓
✓
✓
✓
Group of the system parameters
✓
✓
✓
✓
