Connections
38
En
■
Connecting a Yamaha iPod universal dock
This unit is equipped with the DOCK terminal on the rear panel that
allows you to connect a Yamaha iPod universal dock (such as the
YDS-10, sold separately) where you can station your iPod and
control playback of your iPod using the supplied remote control.
Connect a Yamaha iPod universal dock (such as the YDS-10, sold
separately) to the DOCK terminal on the rear panel of this unit
using its dedicated cable.
■
Using REMOTE IN/OUT jacks
When the components have the capability of the transmission of the
remote control signals, connect the REMOTE IN and REMOTE
OUT jacks to the remote control input and output jacks with the
monaural analog mini cable as follows.
* You can connect another set of infrared signal receiver and Yamaha
component to the REMOTE IN 2 and OUT 2 jacks same as the REMOTE
IN 1 and OUT 1 jacks.
■
Using the TRIGGER OUT jacks
This unit can control the components (for example, the electric
screen, projector, etc.) corresponding to the selected input source
and activating/deactivating the desired zone. This unit sends the 12
V/15 mA direct electric current at the TRIGGER OUT jacks
according to the settings of “Trigger Output” in “Manual Setup”
(see page 114). Connect one of the TRIGGER OUT jack of this unit
and the trigger input jack (or control input jack) of the components
with the monaural analog mini cable as follows.
* You can connect another component to the TRIGGER OUT 2 jack
same as the TRIGGER OUT 1 jack.
The function when you use this feature with the components may vary
depending on the components. Refer to the instruction manuals of the
connected components.
DOCK
Yamaha iPod universal dock
(such as the YDS-10,
sold separately)
(U.S.A. model)
REMOTE
OUT
IN
OUT
IN
1
2
Controlled component
(CD or DVD player, etc.)
*
Remote
control in
Remote
control out
Infrared signal receiver
or controlling
component
Note
TRIGGER
OUT
1
2
Electric screen,
projector, etc.
*
