Recording
66
En
Recording adjustments and other operations are performed from the recording components. Refer to the operating instructions for those
components.
• When this unit is set to the standby mode, you cannot record between other components connected to this unit.
• TONE CONTROL (see page 65) and the volume settings, the speaker level (see page 102) and the sound field programs (see page 58) do not affect recorded
material.
• When this unit is in the Pure Direct mode, no signals output at the OUT (REC) jacks.
• The source connected to the MULTI CH INPUT jacks of this unit cannot be recorded.
• The XM Satellite Radio signals (U.S.A. and Canada models only) cannot be output at the audio OUT (REC) jacks.
• The FM/AM tuner, Internet Radio, PC or MCX audio signals are only output at the analog OUT (REC) jacks.
• Digital signals input at the DIGITAL INPUT jacks are not output at the analog audio OUT (REC) jacks for recording. Likewise, analog signals input at the
AUDIO IN jacks are not output at the DIGITAL OUTPUT jack. Therefore, if your source component is connected to provide only digital or analog signals,
you can only record digital or analog signals.
• A given input source is not output on the same OUT (REC) channel.
• S-video and composite video signals pass independently through the video circuits of this unit. Therefore, when recording or dubbing video signals input
from a video source component that provides only an S-video or a composite video signal, you can record only an S-video or a composite video signal on
your VCR.
• The analog audio and video signals input at the DOCK terminal can be output at the analog audio OUT (REC) jacks and DVR or VCR OUT jacks for
recording.
• Check the copyright laws in your country to record from CDs, radio, etc. Recording of copyrighted material may infringe copyright laws.
y
Do a test recording before you start an actual recording.
1
Turn on all the connected components.
2
Press
P
REC OUT/ZONE2
until the RECOUT
indicator lights up in the front panel display.
This unit in the recording source selecting mode.
3
Rotate
M
PROGRAM
to select the source
component you want to record from.
Carry out the operation while the RECOUT indicator is lit.
y
Select “SOURCE” to record the currently selected input source.
4
Start playback on the selected source component or
select a broadcast station.
5
Start recording on the recording component.
Recording
Caution
The DTS signal is a digital bitstream. Attempting to digitally record the DTS bitstream will result in noise being recorded. Therefore, if
you want to use this unit to record sources encoded in DTS, the following considerations and adjustments need to be made. To play DTS-
encoded DVDs and CDs (when using a digital audio connection) on your DTS-compatible player, follow its operating instructions to
make a setting so that the analog signal will be output from the player.
Notes
If you play back a video source that uses scrambled or encoded signals to prevent it from being dubbed, the picture itself may be disturbed due to those
signals.
RECOUT
