FM/AM tuning
68
En
There are 3 tuning methods: automatic, manual and direct frequency. Automatic tuning is effective when station signals are strong and there
is no interference. If the signal from the station you want to select is weak, tune into it manually. You can also tune into the desired station by
entering the frequency. You can use the automatic and manual preset tuning features to store up to 40 stations (A1 to E8: 8 preset station
numbers in each of the 5 preset station groups). Furthermore, you can recall any preset stations and exchange the assignment of two preset
stations with each other.
(U.S.A. model only) This unit is equipped with an HD Radio reception feature. The operations of the HD Radio tuning are same as the
conventional FM/AM tuning. For details about the specific features of the HD Radio, refer to “Using HD Radio™ features (U.S.A. model
only)” on pages 72 to 73.
Orient the connected FM and AM antennas for the best reception.
Automatic tuning is effective when station signals are strong and
there is no interference.
1
Rotate the
D
INPUT
selector (or press
3
TUNER
) to
select “TUNER” as the input source.
y
(U.S.A. model only) “HD Radio” appears in the front panel display
when the tuner mode is set to the HD Radio reception mode.
2
Press
K
BAND
(or
8
BAND
) repeatedly to select the
desired reception band.
“FM” or “AM” appears in the front panel display.
3
Make sure that the AUTO indicator lights up and a
colon (:) does not appear in the front panel display.
y
• If the AUTO indicator does not light up in the front panel display, this
unit is in the manual tuning mode. Press
I
TUNING MODE
on the
front panel to set this unit to the automatic tuning mode.
• If a colon (:) appears in the front panel display, this unit is in the
preset station tuning mode, and automatic tuning is not possible.
Press
L
PRESET/TUNING
(or
I
SRCH MODE
) to turn the colon
(:) off.
4
Rotate
M
PROGRAM
(or press
9
PRESET/CH
k
/
n
)
to begin automatic tuning.
When this unit is tuned into a station, the TUNED indicator
lights up and the frequency of the received station is shown in
the front panel display.
• Rotate
M
PROGRAM
rightward (or press
9
PRESET/
CH
k
) to tune into higher frequency.
• Rotate
M
PROGRAM
leftward (or press
9
PRESET/
CH
n
) to tune into a lower frequency.
y
(U.S.A. model only) If the station that you tune this unit into is the HD
Radio station, the HD indicator also appears in the front panel display.
See page 72 for details about the HD Radio features.
FM/AM tuning
Note
Before performing the following operations, set the operation mode
selector on the remote control to
F
SOURCE
.
Automatic tuning
AUTO
A F M 8 8 . 9 M H z
Lights up
No colon (:)
(U.S.A. model)
Tuning information in the video monitor
You can display the FM/AM tuning information in the video monitor.
Press
K
DISPLAY
on the remote control repeatedly to turn the
information display on and off.
y
• (U.S.A. model only) If the station that you tune this unit into is the HD
Radio station, HD Radio information appears in the video monitor. See
page 73 for details.
• You can set the time for which the tuning information is displayed in
the video monitor by using the “On Screen” parameter in “Manual
Setup” (see page 108).
• You can display the tuning information in the Zone video monitor (see
STEREO AUTO
TUNED
