XM™ Satellite Radio tuning (U.S.A. and Canada models only)
76
En
■
Direct Number Access mode
1
Press
I
SRCH MODE
on the remote control
repeatedly to select “ALL CH SEARCH” or “CAT
SEARCH”.
2
Press the numeric buttons (
B
) on the remote control
to enter the desired three-digit channel number.
For example, to enter the number 123, press the numeric
buttons as shown below.
The display changes as follows.
y
• To enter a one-digit or two-digit channel number, press the numeric
buttons (
B
) on the remote control and then press
N
ENT
to confirm the
input number.
• If no button is pressed within a few seconds after you enter a one-digit or
two-digit number, this unit automatically confirms the entered channel
number.
• If you enter the number 0, this unit displays your XM Radio ID (see
You can use this feature to store up to 40 XM Satellite Radio
channels (A1 to E8: 8 preset channel numbers in each of the 5
preset channel groups). You can then recall any preset channel
easily by selecting the preset channel group and number as
described in “Preset Search mode” on page 75.
1
Search for a channel you want to set as a preset
channel by using one of the XM Satellite Radio
search modes.
2
Press
J
MEMORY
(or
0
MEMORY
).
The MEMORY indicator flashes in the front panel display for
approximately 10 seconds.
You must proceed to and carry out steps 3 through 5 while the
MEMORY indicator is flashing in the front panel display.
3
Press
M
PROGRAM
(or
9
CAT.
l
/
h
) repeatedly to
select a preset channel group (A to E) while the
MEMORY indicator is flashing.
The preset channel group letter appears in the front panel
display.
4
Rotate
M
PROGRAM
(or
9
PRESET/CH
k
/
n
)
repeatedly to select a preset channel number (1 to 8)
while the MEMORY indicator is flashing.
The preset channel number appears in the front panel display.
A L L C H S E A R C H
C A T S E A R C H
or
CLASSICAL 1
1
CLASSICAL 2
2
LIVE/CLUB
3
< X M > - - 1
< X M > - 1 2
< X M > 1 2 3
Before performing the following operations, set the operation mode
selector on the remote control to
F
SOURCE
and then press
3
XM
.
Setting the XM™ Satellite Radio preset
channels
Note
[ 0 4 3 ] X M U
Currently selected channel number
MEMORY
Flashes
MEMORY
C
[ 0 4 3 ] X M U
Currently selected preset channel group
Flashes
MEMORY
C 5
[ 0 4 3 ] X M U
Currently selected preset channel number
Flashes