13
En
Connections
English
PRE
P
ARA
T
ION
■
Before connecting to the SPEAKERS
terminal
A speaker cord is actually a pair of insulated cables
running side by side. Cables are colored or shaped
differently, perhaps with a stripe, groove or ridges.
Connect the striped (grooved, etc.) cable to the “+” (red)
terminals of this unit and your speaker. Connect the plain
cable to the “–” (black) terminals.
Remove approximately 10 mm (3/8”) of insulation
from the end of each speaker cable and then
twist the bare wires of the cable together to
prevent short circuits.
■
Connecting to the SPEAKERS terminals
1
Loosen the knob.
2
Insert the bare end of the speaker wire into
the hole on the terminal.
3
Tighten the knob to secure the wire.
Connecting the banana plug
(except Korea and Asia models)
The banana plug is a single-pole electrical connector
widely used to terminate speaker cables. First, tighten the
knob and then insert the banana plug connector into the
end of the corresponding terminal.
1
Make sure this unit is turned off.
See page 19 for details about turning on or off this
unit.
2
Press and hold
0
TONE CONTROL
and
then press
1
STANDBY/ON
to turn on this
unit.
This unit turns on, an the advanced setup menu
appears in the front panel display.
3
Press
A
PROGRAM
l
/
h
repeatedly to
select “SP IMP.”.
The following display appears in the front panel
display.
4
Press
B
STRAIGHT
repeatedly to select “6
Ω
MIN”.
The following display appears in the front panel
display.
5
Press
1
STANDBY/ON
to confirm your
selection and set this unit to the standby
mode.
The setting you made is reflected next time you turn on this unit.
10 mm (3/8”)
1
2
3
Red: positive (+)
Black: negative (–)
Banana plug
Setting the speaker impedance
(U.S.A. and Canada models only)
Caution
If you are to use 6 ohm speakers, set “SP IMP.” to “6
Ω
MIN” as follows BEFORE using this unit.
Note
S P
I M P . - 8
M I N
S P
I M P . - 6
M I N
