Reference Manual
Appendix
157
Wrong pitch or unexpected pitch
Is the Tune parameter in the Utility mode set to a value other than “0”?
[UTILITY]
General
Tune (
)
Is the Note Shift parameter in the Utility mode set to a value other than “0”?
[UTILITY]
General
Note Shift (
When the Voice produces a wrong pitch, is the appropriate tuning system selected from
Micro Tune parameter in the Voice Edit mode?
[UTILITY]
Micro Tune (
)
When the Performance/Multi produces a wrong pitch, is the Note Shift parameter of
each Part set to a value other than “0”?
[PERFORM]
[EDIT]
Part selection
Play Mode (
)
[MULTI/SEQ PLAY] (selecting Multi mode)
[EDIT]
Part selection
Play Mode (
)
No effect is applied
Have the REVERB and CHORUS Knobs/Sliders been turned fully to the minimum?
Have any or all of the effect types been set to “thru” or “off”?
Is the EFFECT ON/OFF parameter of each Effect set to OFF?
When this occurs in the Performance/Multi mode, check whether the Insertion Switch
(Ins Effect Sw) parameters are set properly or not.
[PERFORM]
[EDIT]
Part selection
FX Send
Ins Effect Sw (
[MULTI/SEQ PLAY] (selecting Multi mode)
[EDIT]
Part selection
FX Send
Ins Effect Sw (
)
Vocoder does not work when selecting a Vocoder Voice
Is the output of the A/D Input Part set to “vocoder”?
[UTILITY]
Voice
A/D Out
Output Select (
[PERFORM]
[EDIT]
Common
A/D Out
Output Select (
[MULTI/SEQ PLAY] (selecting Multi mode)
[EDIT]
Common
A/D Out
Output Select (
)
The Edit Indicator appears, even when parameters are not being edited
Keep in mind that even though the Edit mode is not active, simply moving a Knob/
Slider changes the current Voice, Performance, or Multi, causing the Edit Indicator to
appear.
Some Arpeggio types include MIDI Control Change messages. When you play back
such an Arpeggio type, the sound of the current Voice may inadvertently be changed
and the Edit Indicator may appear in the top right of the display.