Reference Manual
Reference
33
Name
Play Mode
Arpeggio
Controller
Filter/EG
3 Band EQ
Using the MIC INPUT jack
By connecting a microphone to the MIC INPUT jack located on the rear panel of this instrument, you can enjoy singing
along with your own performance. To the signal input via the MIC INPUT jack, you can apply the Effect of this instrument,
including the Vocoder Effect. The example below assumes you want to sing while playing the keyboard.
1
Connect the microphone to the MIC INPUT jack.
2
To turn the Mic Input on, press the [MIC ON/OFF] button.
3
Use the INPUT GAIN knob to adjust the input level of the signal.
Adjust the input gain so that the PEAK lamp flashes briefly when you play at your loudest level.
4
Select “MIC” by pressing the Knob Function button then adjust the volume by using the knob to
which the VOLUME is assigned.
5
As necessary, adjust PAN, CHO SEND, REV SEND by using the assigned knobs.
You can also apply various effects to your voice.
1
Press the [UTILITY] button to enter the Utility mode.
2
Select the “Voice” in the Utility Select display, then press [ENTER] button.
3
Select “A/D FX,” then press the [ENTER] button.
4
Select “InsA,” then press the [ENTER] button.
5
Move the cursor to the Effect category, then select the desired category by using the Data Dial,
[DEC] and [INC] buttons.
6
Move the cursor to the Type, then select the desired effect type by using the Data Dial, [DEC] and
[INC] buttons.
Other Functions
In the Voice Play mode, you can select the design of display called “Simple” display by holding the [SHIFT] button then
pressing the cursor [
L
][
R
] buttons. The Simple display shows the Voice Name in a large font. Three types of character
are available and can be selected.
NOTE:
When changing to the Simple display, the displayed Voice name scrolls. To stop scrolling, press the [EXIT] button. Press the
[ENTER] button to scroll the Voice name again.
The panel lock function can temporarily disable the panel operation and prevent unintended operation during live
performance. When you press the [PANEL LOCK] button, its lamp will light and all the buttons/Knobs/Sliders except for
the Master Volume/Input Gain/Pitch Bend wheel/Modulation wheel/foot switch will be locked. Press the [PANEL LOCK]
button again to cancel the Panel Lock.
NOTE:
You can set the buttons to which the Panel Lock function is applied in the Panel Lock display (
) of Utility. When setting
the target of the panel lock as except to “All,” the [PANEL LOCK] button will flash while turned on.
Enhancing the Sound with Effects
Calling up the Simple display
Panel Lock Function
Simple display 1
Simple display 2
Simple display 3