10
Using the Controls
■
Using the LINE OUT jack
(Using with a guitar amplifier or powered speaker, etc.)
1.
Use a standard phone plug cable to connect the Silent Guitar’s LINE OUT jack to the input jack on the
guitar amplifier or powered speaker, etc.
When the cable’s plug is inserted into the LINE OUT jack, power will be supplied to the Silent Guitar
and the power lamp will light.
• Before making any connections, make sure that the output volume on the guitar amplifier or powered
speaker, etc., is turned down or its power is switched OFF.
• When the guitar is not being used, disconnect the cable’s plug to save battery.
2.
Rotate the VOLUME knob while playing, and adjust the volume to a suitable level.
• If the sound is distorted when playing vigorously, turn the VOLUME knob slightly to the left.
3.
Rotate the BASS and TREBLE control knobs to adjust the sound quality.
Rotate the BASS knob to the right to increase the low frequencies, and to the left to decrease the low
frequencies.
Rotate the TREBLE knob to the right to increase the high frequencies, and to the left to decrease the high
frequencies.
4.
The REVERB function can be used for adding reverb to the guitar’s tone to produce the live acoustic
characteristics experienced in a room or hall.
Set the REVERB switch to its “1” position to add the type of reverb usually experienced in a room, or set
the switch to its “2” position to add the type of reverb normally experienced in a hall.
• When compared to the REVERB switch’s REVERB 1 or REVERB 2 positions, the instrument consumes
less power when the REVERB switch is in its OFF position.
• Some noise is produced when the position of the REVERB switch is changed.
■
Using the stereo earphones
(or stereo output to an external device)
When using the instrument with the supplied stereo earphones or a separately purchased pair of
headphones, or when you want to send the instrument’s stereo output to an external device, use
the headphones (PHONES) jack for connecting the earphones or external device.
1.
Set the headphones ON/OFF switch, located on the right side of the control panel, to its “ON” position
to supply power to the Silent Guitar. The power lamp will light.
2.
Insert the earphone plug into the headphone jack. When connecting the instrument to an external device,
connect the external device to the PHONES jack using a cable with a stereo plug.
3.
The remaining procedures are the same as described above in the “Using the LINE OUT jack” section’s
steps 2 through 4.
• When using a pair of headphones, do not operate at high volume levels for long periods of time. Doing so
can lead to irreparable damage to your hearing.
• Do not disconnect or connect the plug when the headphones are placed over your ears.
When the power is
ON, the lamp lights.
Adjusts high
frequencies
Adjusts the
volume
Adjusts low
frequencies
OFF 1 2
OFF ON
PHONES
REVERB
VOLUME
BASS
TREBLE
02_slg100s_en.pm65
06.8.22, 11:05 AM
10
