background image

2

En

PLACING THE  SPEAKER

Place the speaker on top of the TV or inside the TV rack so
that the speaker and TV are aligned vertically.

Notes

Do not place the speaker on top of the TV whose area is
smaller than the bottom area of the speaker. If placed,
the speaker may fall and cause injury.

Do not place the speaker on top of the TV with an
inclination.

This speaker features a magnetically shielded
design, but there is still a chance that placing it too
close to a TV set might impair picture color or create
a buzzing noise. Should this happen, move the
speaker away from the TV set.

Front

Surround

Subwoofer

SUPPLIED ACCESSORIES

Fastener (4 sets)

Fastener

Soavo-900C

Peal off
the seal.

When placing the speaker on top of the TV
rack, etc.

Attach the provided fasteners at two points on the bottom
of the speaker and on top of the TV rack.

Thoroughly wipe clean the surface where the
fastener is to be applied. Note that adhesive
strength is weakened if the surface is dirty, oily or
wet and that this may cause the center speaker to
drop.

Do not touch the adhesive surface after peeling off
the seal as this will weaken its adhesive strength.

01_En_Soavo-900C_URGT.p65

7/31/06, 9:11 AM

2

Summary of Contents for Soavo-900C

Page 1: ... selecting this YAMAHA Soavo 900C speaker system Do not place the speaker where it is liable to be knocked over or struck by falling objects Stable placement will also ensure better sound performance Placing the speaker on the same shelf or rack as the turntable can result in feedback Never put a hand or a foreign object into the port located on the rear of the speaker as this might cause personal...

Page 2: ...re color or create a buzzing noise Should this happen move the speaker away from the TV set Front Surround Subwoofer SUPPLIED ACCESSORIES Fastener 4 sets Fastener Soavo 900C Peal off the seal When placing the speaker on top of the TV rack etc Attach the provided fasteners at two points on the bottom of the speaker and on top of the TV rack Thoroughly wipe clean the surface where the fastener is to...

Page 3: ...the coating off 3 Insert the bare wire in to the hole 4 Tighten the knob and secure the cable Test the firmness of the connection by pulling lightly on the cable at the terminal Notes Do not let the bare speaker wires touch each other as this could damage the speaker or the amplifier or both of them Do not insert the insulation coating into the hole The sound may not be produced When using a banan...

Page 4: ...packed separately To attach the front cover line up the four salients magnet on the reverse side of the front cover with the four corresponding pegs Notes When the cover is not attached take care not to touch the speaker units with your hands or to exert excessive force with tools There are magnets on the reverse side of the front cover Do not place the front cover close to objects that might be a...

Reviews: