Yamaha sonogenic SHS-300, Owner'S Manual

6

SHS-300 Owner’s Man

u

al

- Always make sure all batteries are inserted in 

conformity with the +/- polarity markings.

- When the batteries run out, or if the 

instrument is not to be used for a long time, 
remove the batteries from the instrument.

- When using Ni-MH batteries, follow the 

instructions that came with the batteries. Use 
only the specified charger device when 
charging.

• Keep batteries away from small children who 

might accidentally swallow them.

• If the batteries do leak, avoid contact with the 

leaked fluid. If the battery fluid should come in 
contact with your eyes, mouth, or skin, wash 
immediately with water and consult a doctor. 
Battery fluid is corrosive and may possibly 
cause loss of sight or chemical burns.

If you notice any abnormality

• When one of the following problems occur, 

immediately turn off the power switch and 
disconnect the electric plug from the outlet. 
(If you are using batteries, remove all batteries 
from the instrument.) Then have the device 
inspected by Yamaha service personnel.
- The USB cable or plug becomes frayed or 

damaged.

- It emits unusual smells or smoke.
- Some object has been dropped into the 

instrument.

- There is a sudden loss of sound during use 

of the instrument.

- If any cracks or breakages exist on the 

instrument.

 CAUTION

Always follow the basic precautions listed 
below to avoid the possibility of physical 
injury to you or others, or damage to the 
instrument or other property. These 
precautions include, but are not limited to, 
the following:

Power supply

• Do not connect the instrument to an electrical 

outlet using a multiple-connector. Doing so 
can result in lower sound quality, or possibly 
cause overheating in the outlet.

• When removing the electric plug from the 

instrument or an outlet, always hold the plug 
itself and not the USB cable. Pulling by the 
cable can damage it.

• Remove the electric plug from the outlet when 

the instrument is not to be used for extended 
periods of time, or during electrical storms.

• Use the specified USB power adaptor (pages 

17, 33) only. Using the wrong adaptor can 
result in damage to the instrument or 
overheating.

Location

• Do not place the instrument in an unstable 

position where it might accidentally fall over.

• Before moving the instrument, remove all 

connected cables, to prevent damage to the 
cables or injury to anyone who might trip over 
them. 

• When using an electric plug, make sure that 

the AC outlet you are using is easily 
accessible in plain view. If some trouble or 
malfunction occurs, immediately turn off the 
power switch and disconnect the plug from 
the outlet. Even when the power switch is 
turned off, electricity is still flowing to the 
product at the minimum level. When you are 
not using the product for a long time, make 
sure to disconnect the plug from the wall AC 
outlet.

DMI-7

 2/3