Studio Manager V2 Installation Guide (for DM2000/02R96/DM1000/01V96)
5
ENGLISH
System Hookup
The following illustration shows the available hookup methods
you can use to connect your Yamaha mixing console to your
computer: serial, USB, MIDI.
Configuring Your Yamaha Mixing
Console
Press the DISPLAY ACCESS [SETUP] button to open the MIDI/
TO HOST Setup page. Under “Studio Manager,” select a port
and assign an ID to your Yamaha mixing console. If you’ve
connected the DM2000/02R96 to the serial port, set the TO
HOST SERIAL options as appropriate (i.e., “PC-2” for a
Windows PC, or “Mac” for a Macintosh computer).
Caution when using a USB connection
If you’ve used the USB TO HOST connector to connect to your
computer, you must perform the following actions. If you fail to
do so, your computer or the connected mixing console may
hang up, causing data damage or loss. If your computer or
mixing console hangs up, turn off the power, and restart your
computer.
• Disable the energy conservation mode (suspend/sleep/
standby/hibernate) on your computer before connecting your
computer via the USB TO HOST connector.
• Connect the USB TO HOST connector to your computer
before powering-on the mixing console.
• Close all application programs (such as StudioManager)
before powering the mixing console on/off or connecting/
disconnecting the USB cable.
• Wait at least three seconds between turning the mixing
console on or off, and between connecting and disconnecting
the USB cable.
Adobe Reader
Adobe Reader (available free of charge) must be installed on
your computer in order for you to view the PDF format manuals
for Studio Manager and the various editors. If you don’t have
Adobe Reader, access the Adobe Corporation website at the URL
shown below, and download Adobe Reader.
http://www.adobe.com
USB MIDI Driver
If you are connecting your Yamaha mixing console to a USB
port on your computer, you’ll need to install the Yamaha USB
driver. If you already have this driver installed, skip this section.
The procedure you use for installing the Yamaha USB driver
depends on which version of Windows you’re using:
• Windows 98 & 98SE: See page 6
NOTE:
Before you connect to serial or MIDI ports, turn off your
Yamaha mixing console and computer.
Warning:
Do not set the TO HOST SERIAL option to “Mac” while
your Yamaha mixing console is connected to your computer’s serial
port. Doing so may damage your computer.
USB cable
(Yamaha CCJ-Mac
or equivalent)
(Yamaha CCJ-PC2
or equivalent)
USB port
Serial cable
Mac serial port
PC serial port
Yamaha mixing console rear panel
Mac or PC
MIDI interface
MIDI cables
3. MIDI
2. USB
1. Serial
(DM2000/02R96 only)
TO HOST
USB
IN
OUT
Windows Installation
NOTE:
Studio Manager is supported by only Windows 2000/XP.
The driver for Windows 98/98SE/Me is necessary if you use other
MIDI applications on Windows 98/98SE/Me.
Studio
Manager
Yamaha
mixing console
Computer
USB cable
Driver
