DM2000V2 Quick Start Guide
10/28
ENCODER MODE / FADER MODE
The encoders above the faders can be used to edit various channel parameters. The most useful ones are PAN and AUX
SEND.
To edit PAN on the encoders,
just press the
[PAN] ENCODER MODE button and turn
the required encoder. The pan position will
be displayed in the fluorescent window
above the channel faders.
To see the Aux send information for many channels at the
same time,
press the AUX SELECT [DISPLAY] button. Each
time this button is pressed, it will change the LCD to a differ-
ent page to see the information for other channels. In these
pages PRE/POST status can be edited, and the AUX SENDS
can be turned off by pressing [ENTER] while the cursor is
high-lighting the Level encoder.
To edit AUX on the encoders,
press the
[AUX/MTRX] ENCODER MODE but-
ton, then select the required AUX# (1-12)
with one of the [AUX#] SELECT buttons
above. The Aux level will be displayed in
the fluorescent window above the chan-
nel faders.
When the [AUX/MTRX] FADER MODE button is
pressed,
the AUX SEND levels are shown
on the
faders instead of the channel level. Choose which
Aux to see on the faders with the [AUX#] SELECT
buttons (as in step 2 above). Press the [FADER]
FADER MODE button to resume normal level
operation on the faders.
