Yamaha SWP1-16MMF, Owner'S Manual

SWP1 Owner’s Manual

11

Controls and Functions

Front panel

The explanation here is based on the SWP1-16MMF. 

1

LAN ports

These are etherCON (RJ-45) ports for connecting 
Ethernet cables (CAT5e or better is recommended). 
A cable with an RJ-45 connector can also be 
connected.
All ports support 1000BASE-T, 100BASE-TX, and 
10BASE-T.

2

MMF port

This is an opticalCON DUO port for connecting an 
optical fiber cable. LC Duplex connectors can also 
be connected.
If you use a cable with an LC Duplex connector, 
fasten the dust cap attached to the cable connector 
to prevent dust from adhering when the cable is not 
in use. You can expand the MMF ports by installing 
an optional MMF-SWP1 in the location where a cover 
is attached. Installation of the MMF-SWP1 must be 
performed by a Yamaha service engineer. Customers 
must not attempt to perform the installation 
themselves.

NOTE

• Use an opticalCON DUO multi-mode optical fiber cable 

made by Neutrik Corporation. Since optical fiber cables 
are vulnerable to being bent or pulled, you can reduce 
the occurrence of problems by using a cable that has a 
strong sheath and is equipped with a locking mechanism.

• Use GI-type multi-mode fiber cables that have a core 

diameter of approximately 50 μm and cladding diameter 
of approximately 125 μm. The maximum length between 
devices is 300 m

Cleaning

Correct communication might not be possible if 
debris and/or dust has adhered to the ends of optical 
fiber cables or the ports. Clean the equipment 
regularly by using commercially available optical 
fiber cleaning products.

3

LED mode indicators

This indicates what the status indicators are showing.

4

[LED MODE] button

This switches what the status indicators are showing.

5

Status indicators

These indicate the status of each port. The displayed 
content depends on the mode. For details on the 
display in each mode, refer to “Status indicator 
display.”

6

DIP switches

These specify startup settings for the unit.
Set the DIP switches when the power is turned off. 
The settings are not applied if you change the setting 
while the power is on.
The switch illustrations indicate the up/down position 
as follows.

• Switch 1 (CONFIG)

Specifies whether the unit’s settings are optimized for 
a Dante network or are set by the user.

1

2

3

4

5

6

7

8

Switch 
position

Status

Represent a status with switch toggled up.

Represent a status with switch toggled 
down.

Switch 
position

Option

Functions

DANTE

The unit starts up with settings 
optimized for a Dante network.

USER

The unit starts up with user 
settings.

1

1